- ページ 5

計測機器 CORNING ONE OIUのPDF クイック・インストール・シートをオンラインで閲覧またはダウンロードできます。CORNING ONE OIU 8 ページ。 Optical interface unit

GROUND CHASSIS (CONTINUED)

Step 1:

Use a wire-stripping tool to remove approximately

0.4- in (10.9 mm) of the covering from the end of

the grounding wire.

Step 2:

Insert the stripped end of the grounding wire into

the open end of the grounding lug.

Step 3:

Crimp the grounding wire in the barrel of the

grounding lug. Verify that the ground wire is

securely attached to the ground lug by holding the

ground lug and gently pulling on the ground wire.

Step 4:

Prepare the other end of the grounding wire and

connect it to an appropriate grounding point at the

site to ensure adequate earth ground.

FIBER CONNECTIONS

Using an MTP®-LC APC harness cable:

• Connect the harness cables' MTP® connector to the

OIM MTP connector

• Remove the protective plastic covers and connect the

(3) LC APC connection fibers to the FMU EDGE™ module

LC APC connections. See Figure 7.

ATTENTION! Take note of the fiber numbering (i.e., 1/2/3).

EXPANDER CONNECTIONS TO HEU

RF expander connections between the OIU and HEU are

performed using the ERFC cable (included in HEU order)

and are described in the HEU quick installation sheet

(CMA-267-AEN) provided with the unit. See Figure 8 for

general view of connections.

Corning Optical Communications

Figure 7. OIMs Fiber Connections

Figure 8. OIX-to-RIX Expander Connection

Quick Installation Sheet | CMA-263-AEN | Page 5