- ページ 2

ラック＆スタンド CORNING Pretium EDGEのPDF マニュアルをオンラインで閲覧またはダウンロードできます。CORNING Pretium EDGE 4 ページ。 Rackless

Tools and Materials Required

•

Phillips-head screwdriver

Rackless Wire Tray Mounting Kit 2U or 4U

X axis

NOTE: This installation requires two people.

Step 1:

The first person places the mini-frame under the wire tray.

Step 2:

The second person aligns the X axis and Z axis brackets over the wire tray in line with the

slots in the mini-frame.

Step 3:

The first person slides the captive screws on the underside of the mini-frame under the X

and Z axis brackets and loosely inserts the screws into the threaded nuts on the brackets.

Step 4:

Adjust the kit location in the X direction (left or right) and tighten the screws in the X axis

brackets from the underside of the mini-frame.

Step 5:

Adjust the kit location in the Z direction (forwards or backwards) so the housing will align

with the front of the cabinet below, if present. Consider the 4.5-inch frontal projection in

your calculations. Tighten the screws on the Z brackets from the underside.

NOTE: Calculate the Z dimension carefully. Once the kit is installed, any adjustment needed along

the Z axis will require that the housing be removed.

STANDARD RECOMMENDED PROCEDURE 003-809 | ISSUE 4 | DECEMBER 2011 | PAGE 2 OF 4

Z axis

Figure 1 — Install Rackless Wire Tray Mounting Kit (2U or 4U) (2U kit shown)

Z axis bracket

X axis bracket

KPA-2557