- ページ 3

ラック＆スタンド CORNING Pretium EDGEのPDF マニュアルをオンラインで閲覧またはダウンロードできます。CORNING Pretium EDGE 4 ページ。 Rackless

Step 6:

Once the kit is secured in position, install the EDGE-01U or EDGE-04U housing, as

applicable, or any other device that has the ability to be installed into a 19-inch rack

space, by securing the mounting brackets on each side into the mounting holes on front

of the kit. If installing only one housing, place it in the top position.

Step 7:

To prevent the housings from tilting in the rack, insert screws into the sides of the housing

as shown in Figure 2.

Rackless Ladder Rack Mounting Kit 2U or 4U

KPA-2517

Step 1:

Loosen the screws as shown in Figure 3 to allow the rails to slide.

Step 2:

Place the mini-frame in the middle of the cross members. Slide the Omega brackets to

the left and right to lock the system in the horizontal (X) axis.

NOTE: The kit is able to move in X and Z directions.

Step 3:

Adjust the kit location in the Z direction (forwards or backwards) so the housing will align

with the front of the cabinet below, if present. Consider the 4.5-inch frontal projection in

your calculations. Tighten the screws on the underside of the mini-frame.

STANDARD RECOMMENDED PROCEDURE 003-809 | ISSUE 4 | DECEMBER 2011 | PAGE 3 OF 4

~4.5 inch

Z axis

X axis

Z axis

X axis

Figure 3 — Install Rackless Ladder Rack Kit (2U or 4U)

~4.5 inch

Figure 2 — Install Housing(s) into Mounting Kit

KPA-2558