- ページ 4
IPカメラ ALIBI ALI-CD5021VSSのPDF クイックインストールとユーザーマニュアルをオンラインで閲覧またはダウンロードできます。ALIBI ALI-CD5021VSS 4 ページ。 Hd-tvi extreme outdoor ir dome camera
ページを印刷する3.
Rock the joystick down (four times) until Image is highlighted (yellow), and then press the joystick
"in" toward the base (select) to open the Image submenu.
4.
With DNR highlighted (see above), press the joystick "in" to select DNR (Digital Noise Reduction),
and then rock the joystick left or right to step through the DNR options available. Stop when the the
best image quality appears, and then push the joystick in again to select the option.
5.
Rock the joystick down once to highlight SHARPNESS, and then press the joystick in to select it.
Rock the joystick left or right until the video image is the sharpest, and then push the joystick in
again to select the option.
6.
Repeat the procedure described above with GAMMA, D-WDR, DEFOG, and SHADING.
If you need to reflect the video image vertically, horizontally, or both, use the MIRROR feature to
7.
make the change.
8.
To return to the Main Menu, rock the joystick down to highlight RETURN, and then push the joystick
in to select it.
9.
To close the OSD menu, rock the joystick up or down to highlight RETURN, and then push the
joystick in to select it.
10.
After making changes to the OSD using the joystick, apply a thin bead of silicone sealant around the
rubber dome gasket, and then reinstall the camera dome cover assembly. Ensure that the inside of
the dome is clean.
CLEANING
Clean the camera dome with an approved glass cleaning solution and a lint free cloth.
Dust can be removed from the unit by wiping it with a soft damp cloth. To remove stains, gently rub
•
the surface with a soft cloth moistened with a mild detergent solution, then rinse and dry it with a
soft cloth.
Remove all foreign particles, such as plastic or rubber materials, attached to the camera housing.
•
These may cause damage to the surface over time.
Do not use benzene, thinner or other chemical products on the camera assembly; these may
dissolve the paint and promote damage of the surfaces. Before using any chemical product,
CAUTION
carefully follow the accompanying instructions.
TROUBLESHOOTING
Problem
Possible Cause
Nothing appears on the screen
- Check the power connection.
- Check the video signal cable connection to the monitor.
The video image is dim or not clear.
- If the camera lens is dirty, clean it with a soft, clean cloth.
- Adjust the monitor controls, if necessary.
- If the camera is facing a very strong light, change the camera position.
- Adjust the lens focus.
The screen is dark.
- Adjust the contrast control of the monitor.
- If you have an intermediate device, set the impedance (75 Ω /Hi-Z)
properly, and check the cable connections.
The camera is not working properly and
- Verify that the camera is correctly connected to an appropriate regulated
the surface of the camera is hot.
power source.
The image on the monitor flickers
- Make sure that the camera isn't facing direct sunlight or fluorescent light.
If necessary,change the camera position.
www.observint.com
4
SPECIFICATIONS
Parameter
Value
Image Sensor:
/
" Sony CMOS image sensor
1
2.9
Active Pixels:
1944(H) x 1092(V) = 2,122,848 (pixels)
HD-TVI: 1080p @ 30 fps
Resolution
720P @6 0/ 50 fps
ANALOG : 700TVL
Color: 1.0 lux, B/W: 0.5 lux
Min. Illumination:
Color DSS: 0.002 lux, B/W DSS : 0.001 lux
Scanning system
Progressive scan
HD-TVI
Video output
Analog without WDR
S/N Ratio
> 50 dB (AGC off)
AGC
0 ~ 20 steps
Shutter speed:
Auto, Manual 1/30 s ~ 1/60,000 s
SENS-UP
Off, ×2 ~ ×8
0 ~ 20 steps
Brightness
Backlight
WDR / BLC / Off
HLC
On / Off
D-WDR
On / Off
Defog
On / Off
Day / Night
TDN (Auto / Day / Night)
White Balance
Auto / Autoext / Manual
DNR (3D)
High / Middle / Low / Off
Mirror
H / V / H&V / OFF
0 ~ 10 steps
Sharpness
Privacy Mask
On / Off (16 zones selectable)
Motion Detection
On / Off
Digital Zoom
On / Off (×1 ~ ×8)
Power Source
12 Vdc ± 10%
Power consumption
3.0 watts max.
Operating temperature
-49 ˚F ~ 49 ˚F (-45˚C ~ 50˚C)
Operating humidity
10% ~ 90%
Lens
2.8 ~ 12 mm DC auto iris MP lens
Dimension
4.65" (W) × 3.48" (H), dome Φ3.15" (118 (W) × 88.5(H), dome Φ80 mm)
Weight
2.89 lb (1310 g) approx.
© 2015 Observint Technologies. All rights reserved.