- ページ 3

デジタルカメラ ALIBI ALI-NS1132VRのPDF クイック・インストール・マニュアルをオンラインで閲覧またはダウンロードできます。ALIBI ALI-NS1132VR 7 ページ。 2mp ip dome camera

ページを印刷する

Step 4.

Activate Inactive Alibi device

NOTE: If the camera LAN extension cable is attached to a Network Video Recorder (NVR), skip this step.

Refer to the documentation available for your NVR firmware for the procedure to activate the camera, if

necessary.

When an Alibi device is first installed, or reset to its factory configuration, it must be "Activated" before it

can be used. In the Alibi Configuration Tool, "Inactive" devices have a Security status of Inactive, and

an IPv4 address of 192.168.1.64. A device is "Activated" when a password is assigned to the admin

username of the device.

In the example below, an ALI-NS1132VR camera is activated and configured for its network. The procedure

is similar for all other Alibi network cameras currently available.

Scan through the list of devices the Alibi Config Tool discovered for the Inactive device you want to

activate (see below). Click on the device in the list to highlight it, and then click the select box to

check it. See below.

Selected

Activate

Click the Activate button. In the Activate window, you will create a password for the admin

(administrator) username.

In the Activate window, enter an a password for admin in the New Password field. Include a

combination of uppercase, lowercase alphabetic characters and numbers to create a "Strong"

password. The rating is shown beneath the Password field. See above.

Enter the admin password again in the Confirm field, and then click Activate. In the screen

below, notice that the device Security status shows "Active". Record your admin password for

reference later.

If you lose your admin (administrator) password, you cannot configure the device or restore



it to its factory settings. To reset your password, call your support organization for specific

CAUTION

instructions.

Notice that although the device is now activated, it retained the default IP address.

Step 5.

Edit Network Parameters

NOTE: If the camera LAN extension cable is attached to a Network Video Recorder (NVR), skip this step.

The camera will receive network configuration settings from the NVR. Refer to the documentation available

for your NVR firmware for more information.

You can change the network parameters of devices that are active.

In the list of devices discovered, click on the device you want to change the network settings for, and

then click the select box to check it. See below.

www.observint.com

Edit Network Parameters

In the popup window, edit the current network parameters, and then enter the Administrator

(admin) user password in the field at the bottom.

Enable DHCP: You can select Enable DHCP to acquire compatible network settings from

a DHCP server installed on the LAN. However, these settings might be changed later by the

DHCP server. Since it is recommended to use an unchanging IP address, you can use DHCP

to acquire compatible network settings, and then uncheck Enable DHCP and save that

configuration to retain the new network parameters.

In the example below, Enable DHCP was checked to acquire compatible network settings

from the DHCP server.

Click OK to save your settings. The parameter change(s) will be shown device's network parameters

(see below).

Step 6.

NOTE: If the camera LAN extension cable is attached to a Network Video Recorder (NVR), skip this step.

Microsoft® IE is used to access your camera remotely. IE must run as an Administrator to use all features

available through a remote login to the camera.

Setting MS Internet Explorer to run as an Administrator

Window 7: To run IE as an Administrator:

Find or create an IE icon on your computer desktop.

Hold down the shift key, and then right-click on the IE icon.

MS Internet

Explorer icon

Click Run as administrator in the pop-up menu.

Run as administrator