- ページ 5
デジタルカメラ ALIBI ALI-NS1132VRのPDF クイック・インストール・マニュアルをオンラインで閲覧またはダウンロードできます。ALIBI ALI-NS1132VR 7 ページ。 2mp ip dome camera
ページを印刷する
Grasp here to
adjust Pan
Adjust the tilt:
c.
i.
Loosen the tilt lock screws enough to tilt the camera module. Do not remove the
screws.
ii.
Adjust the camera module as needed to set the elevation of the video image.
iii.
Tighten the tilt lock screws to hold the position of the tilt.
d.
Adjust the rotation: Grasp the camera module on the sides as shown in the picture below,
and the turn the module as needed to set the horizontal line of the video image.
Grasp here
to adjust
Rotation
Lower
dome
assembly
Dome alignment notch
2.
Reinstall the black liner.
3.
Reinstall the dome assembly. When positioning the dome assembly on the camera lower dome
assembly, ensure that the peg on the edge of the dome assembly aligns with the notch in the lower
dome assembly. See the photo above.
Step 8.
Verify Zoom functionality
Use the PTZ control panel to exercise the zoom and focus functionality of the camera. Accessing to the
control panel depends on whether the camera is installed as a device on a LAN or if it is connected to a
NVR. Select the installation type below for your camera to complete this step.
www.observint.com
5
For cameras installed on a LAN
Pan range:
0˚ ~ 355˚
1.
Grasp here to
adjust Pan
2.
Tilt range:
3.
0˚ ~ 70˚
Tilt lock
screw (2)
For cameras connected directly to an NVR
Refer to the firmware manual for your NVR for specific instructions to perform the following:
1.
2.
Rotation range:
0˚ ~ 360˚
Grasp here
to adjust
Rotation
3.
4.
Log into the camera and then open the Live View window.
Open / Close PTZ Control Panel
Click the joystick icon to open the PTZ control panel. See above.
In the PTZ control panel, click each zoom and focus button shown in the graphic below. Verify
that the camera performs as expected. Refer to the Specifications section of this document for zoom
range.
Direction buttons
Continuous
pan
Log into the NVR at the NVR console.
In the Live View display, find the PTZ camera you installed. Click on the camera to open the Quick
Setting toolbar.
PTZ Control icon
Click the PTZ Control icon. See above.
In the pop-up PTZ menu, click the PTZ Control tab. See below.
© 2019 Observint Technologies. All rights reserved..
PTZ Control Panel
Zoom In / Out
Focus Near/far
Zoom In / Out
Focus Near/Far