- ページ 5

DVR HIKVISION DS-9100のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。HIKVISION DS-9100 8 ページ。 Hybrid dvr, nvr, analog dvr
HIKVISION DS-9100 にも：クイック・スタート・マニュアル (13 ページ)

ページを印刷する

Please note that in order to add more than 8 channels of

4CIF IP camera as 4 channels of 720p IP cameras; you

will need to disable some analog channels. Disabling one

analog channel will extend one channel for 4CIF IP

camera. Disabling two channels of analog cameras will

extend one channel for 720p IP camera.

A confirmation message will appear on the screen asking

you to reboot the DVR. Click Yes to reboot. After the system

has rebooted, enter back into the Camera Management menu

and continue with the following steps.

list are those supported by SADP and found by the DVR.

If no device was found, you may manually enter the camera

parameters in the fields below.

6. Enter IP camera parameters. This includes the IP address,

ports, user name and password of the IP camera.

7. Select OK to save and return to the Camera Management

menu.

1. Enter the Camera

Management menu

by clicking Menu >

Setting > Camera.

2. Determine

number of analog

channels to disable.

3. To disable analog

channels, click the

Status button to enter

the Camera Enabled

Status menu. Uncheck

checkboxes to disable

corresponding

channels. Click OK to

save setting.

4. Select the Add

button to enter IP

Channel Settings

menu.

5. Select the IP device

from the list. The

devices found in the

Quick Start Guide - DS-9000 / DS-9100 Series DVR

8. If IP camera was

added successfully, the

Status for that camera

would show that it is

Connected. If it does

not, click the Set

button to verify that

the parameters were entered correctly. You may also delete

an added channel by clicking the Delete button.

9. Click OK to exit out of the Camera Management menu.

To adjust IP camera compression settings:

1. Enter the Record

Settings menu by

clicking Menu >

Setting > Record.

2. Select the General

tab.

3. Select the IP camera to configure next to the Camera

label.

4. Adjust IP camera compression settings. If the IP camera

was added successfully, the DVR will show OSD, channel

name and the compression parameters in accordance to the IP

camera's current settings.

5. Select the Sub

stream Settings tab to

enter the Sub stream

Settings menu.

6. Configure sub

stream settings. Sub

stream is only used for

previewing.

7. Click OK to save and exit out of menu.

Note:

The quality of resolution, frame rate and bit rate

depends on the performance of the IP camera.