HIKVISION DS-9100 Schnellstart-Handbuch - Seite 5
Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für DVR HIKVISION DS-9100 herunter. HIKVISION DS-9100 8 Seiten. Hybrid dvr, nvr, analog dvr
Auch für HIKVISION DS-9100: Schnellstart-Handbuch (13 seiten)
Seite drucken
Please note that in order to add more than 8 channels of
4CIF IP camera as 4 channels of 720p IP cameras; you
will need to disable some analog channels. Disabling one
analog channel will extend one channel for 4CIF IP
camera. Disabling two channels of analog cameras will
extend one channel for 720p IP camera.
A confirmation message will appear on the screen asking
you to reboot the DVR. Click Yes to reboot. After the system
has rebooted, enter back into the Camera Management menu
and continue with the following steps.
list are those supported by SADP and found by the DVR.
If no device was found, you may manually enter the camera
parameters in the fields below.
6. Enter IP camera parameters. This includes the IP address,
ports, user name and password of the IP camera.
7. Select OK to save and return to the Camera Management
menu.
1. Enter the Camera
Management menu
by clicking Menu >
Setting > Camera.
2. Determine
number of analog
channels to disable.
3. To disable analog
channels, click the
Status button to enter
the Camera Enabled
Status menu. Uncheck
checkboxes to disable
corresponding
channels. Click OK to
save setting.
4. Select the Add
button to enter IP
Channel Settings
menu.
5. Select the IP device
from the list. The
devices found in the
Quick Start Guide - DS-9000 / DS-9100 Series DVR
8. If IP camera was
added successfully, the
Status for that camera
would show that it is
Connected. If it does
not, click the Set
button to verify that
the parameters were entered correctly. You may also delete
an added channel by clicking the Delete button.
9. Click OK to exit out of the Camera Management menu.
To adjust IP camera compression settings:
1. Enter the Record
Settings menu by
clicking Menu >
Setting > Record.
2. Select the General
tab.
3. Select the IP camera to configure next to the Camera
label.
4. Adjust IP camera compression settings. If the IP camera
was added successfully, the DVR will show OSD, channel
name and the compression parameters in accordance to the IP
camera's current settings.
5. Select the Sub
stream Settings tab to
enter the Sub stream
Settings menu.
6. Configure sub
stream settings. Sub
stream is only used for
previewing.
7. Click OK to save and exit out of menu.
Note:
The quality of resolution, frame rate and bit rate
depends on the performance of the IP camera.
5