- ページ 7

レンジ KitchenAid YKESA907PS00のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。KitchenAid YKESA907PS00 20 ページ。 30"(76.2cm) freestanding and slide-in electric ranges

Place template on the floor in cabinet opening so that the left

edge is against cabinet and top edge is against rear wall,

molding or cabinet.

Tape template in place.

If countertop is not flush with cabinet opening edge, align

template with overhang.

--J

If cabinet opening is wider than specified in the "Location

Requirements"

section, adjust template so range will be

centered in cabinet opening.

To mount anti-tip bracket to wood floor, drill two 1/8"(3.2 mm)

holes at the positions marked on the bracket template.

Remove template from floor.

8. Move range close to opening. Remove shipping base,

cardboard or hardboard from under range.

9. Connect power supply cord as described in the "Electrical

Connection"

section.

10. Move range into final position making sure rear leveling leg

slides into anti-tip bracket.

11. Continue installing your range using the following installation

instructions.

If you are installing a slide-in range into an existing freestanding

range opening, you may use the rear spacer cover to fill in the

opening at rear of range.

Remove the outside screws from the rear trim on range. Use

screws to attach rear spacer bar to range.

To mount anti-tip bracket to concrete or ceramic floor, use a

3A6"(4.8 mm) masonry drill bit to drill 2 holes at the positions

marked on the bracket template. Remove template from floor.

6. Tap plastic anchors into holes with a hammer.

7. Align anti-tip bracket holes with holes in floor. Fasten anti-tip

bracket with screws provided.

A. Rear spacer cover

B. Attach using 2 screws

Depending on the thickness of your flooring, longer screws

may be necessary to anchor the bracket to the subfloor.

Longer screws are available from your local hardware store.