- ページ 7

レンジ KitchenAid YKFEG500ESSのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。KitchenAid YKFEG500ESS 20 ページ。 Freestanding
KitchenAid YKFEG500ESS にも：クイック・スタート・マニュアル (2 ページ), オーナーズマニュアル (18 ページ)

ページを印刷する

6. Repeat steps 1 and 2 to ensure that the range foot is

engaged in the anti-tip bracket.

If the rear of the range lifts more than ½" (1.3 cm) off the floor

without resistance, the anti-tip bracket may not be installed

correctly. Do not operate the range without anti-tip bracket

installed and engaged. Please reference the "Assistance or

Service" section of the Use and Care Guide, or the cover or

"Warranty" section of the User Instructions, to contact service.

Warming Drawer or Premium Storage

Drawer

(on some models)

Remove all items from inside the warming drawer or premium

storage drawer, and allow the range to cool completely before

attempting to remove the drawer.

To Remove:

1. Open the warming drawer or premium storage drawer to its

fully open position.

2. Using a flat-blade screwdriver, gently loosen the warming

drawer or premium storage drawer from the glide alignment

notch and lift up the drawer alignment tab from the glide.

A. Flat-blade screwdriver

B. Drawer alignment tab

C. Drawer glide notch

3. Repeat Step 2 on the other side. The warming drawer or

premium storage drawer is no longer attached to the drawer

glides. Using both hands, pick up the warming drawer or

premium storage drawer to complete the removal.

To Replace:

1. Align the forward drawer notches with the notches in the

drawer glides on both sides. Place the rear alignment tabs

into the drawer glides on both sides.

A. Drawer alignment tab

B. Drawer glide notch

2. Push the warming drawer or premium storage drawer in all

the way.

3. Gently open and close the warming drawer or premium

storage drawer to ensure it is seated properly on the glides

on both sides.

Storage Drawer

(on some models)

The storage drawer can be removed. Before removing, make sure

drawer is cool and empty.

To Remove:

1. Pull the storage drawer straight back to the drawer stop.

A. Drawer stop notch

2. Lift up the front of the drawer and pull the drawer out.

To Replace:

1. Lift up the front of the drawer and place the rear of the drawer

inside the range so that the drawer stop notch is behind the

drawer glide.

2. Lower the drawer so that the edge of the slide rail drops into

the slot in the drawer glide.

3. Slowly push the drawer into the range.

A. Engage drawer glide.

NOTE: When properly installed, the rear slides on the bottom

of the drawer will engage the base rails and the drawer will

not tip when items are placed in the drawer.

If removing the range is necessary for cleaning or maintenance:

1. Slide range forward.

2. Unplug the power supply cord.

3. Complete cleaning or maintenance.

4. Plug in power supply cord.

5. Check that the anti-tip bracket is installed and engaged. See

the "Verify Anti-Tip Bracket Is Installed and Engaged"

section.

6. Check that range is level.