- ページ 14

レンジ KitchenAid YKFEG500EWHのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。KitchenAid YKFEG500EWH 18 ページ。 Freestanding
KitchenAid YKFEG500EWH にも：クイック・スタート・マニュアル (2 ページ)

ページを印刷する

1. Clean Cycle

4-Wire Connection: Direct Wire

Use this method for:

■ New branch-circuit installations (1996 NEC)

■ Mobile homes

■ Recreational vehicles

■ In an area where local codes prohibit grounding through the

neutral

1. Part of metal ground strap must be cut out and removed.

A. Metal ground strap

B. Discard

C. Ground-link screw

2. Use a Phillips screwdriver to remove the ground-link screw

from the back of the range. Save the ground-link screw and

the end of the ground link under the screw.

3. Pull the wires through the strain relief on bottom of range.

Allow enough slack to easily attach wiring to the terminal

block.

A. Terminal block

B. Ground-link screw

C. Cord/conduit plate

D. Bare (green)

ground wire

E. Line 2 (red) wire

F. Neutral (white) wire

G. Line 1 (black) wire

4. Attach terminal lugs to line 1 (black), neutral (white), and line 2

(red) wires. Loosen (do not remove) the setscrew on the front

of the terminal lug and insert exposed wire end through

bottom of terminal lugs. Securely tighten setscrew to torque as

shown in the following Bare Wire Torque Specifications chart.

A. Terminal lug

B. Setscrew

C. Line 2 (red) wire

Bare Wire Torque Specifications

Attaching terminal lugs to the terminal block - 20 lbs-in. (2.3 N-

Wire Awg

8 gauge copper

6 gauge aluminum

5. Use a hex or Phillips screwdriver to connect the bare (green)

ground wire to the range with the ground-link screw and

ground-link section. The ground wire must be attached first

and must not contact any other terminal.

6. Use 3/8" nut driver to connect the neutral (white) wire to the

center terminal block post with one of the 10–32 hex nuts.

A. 10–32 hex nut

B. Line 2 (red)

C. Bare (green) ground

wire

D. Ground-link screw

7. Connect line 2 (red) and line 1 (black) wires to the outer

terminal block posts with 10-32 hex nuts.

8. Securely tighten hex nuts.

9. Replace terminal block access cover.

10. Slide range back so that the rear range foot is engaged in the

anti-tip bracket slot.

D. Neutral (white) wire

E. Line 1 (black) wire

Torque

25 lbs-in. (2.8 N-m)

35 lbs-in. (4.0 N-m)

E. Neutral (white) wire

F. Line 1 (black)

G. Terminal lug