- ページ 12
ヒーター Empire SR-18T-2のPDF 取付説明書および取扱説明書をオンラインで閲覧またはダウンロードできます。Empire SR-18T-2 18 ページ。 Unvented
ページを印刷する
TROUBLESHOOTING INFORMATION FOR QUALIFIED SERVICE PERSON
1. Spark electrode does not produce spark.
a. Spark electrode broken - replace.
b. Ignitor wire may not be attached to spark electrode - attach.
c. Ignitor wire damaged - replace.
d. Piezo ignitor defective - replace.
2. Spark electrode produces spark but pilot does not light.
a. No gas to heater - turn on gas.
b. PILOT position not properly aligned - turn gas control knob
to PILOT position and depress.
c. Pilot is blocked from spider web or dirt - clean pilot, see Page 9.
3. Pilot flame does not stay "ON" when control knob is released.
a. Control knob in PILOT position not completely depressed or
held in long enough.
b. INTERLOCK latching device is operative - see "Lighting
Instructions," Page 11, Step 9.
c. Thermocouple not tightened into gas control - tighten ther-
mocouple.
How To Order Repair Parts...
Parts can be ordered only through your service person or dealer. For best results, the service person or dealer should order parts through the distributor.
Parts can be shipped directly to the service person/dealer.
All parts listed in the Parts List have a Part Number. When ordering parts, first obtain the Model Number from the name plate on your equipment. Then
determine the Part Number (not the Index Number) and the Description of each part from the following appropriate illustration and list. Be sure to give
all this information . . .
Unvented Heater Model Number
Unvented Heater Serial Number
Part Number
Do not order bolts, screws, washers or nuts. They are standard hardware items and can be purchased at any local hardware store.
Shipments contingent upon strikes, fires and all causes beyond our control.
PLEASE NOTE: When ordering parts, it is very important that part number and description of part coincide.
INDEX
PART
NUMBER
NUMBER
1
10812
2
SR-180
3
R-2313
4
SR-008
5
SR-113
6
R-2351
7
R-2406
8
R-2423
9
SR-152
10
SR-214
11
10753
12
R-5097
12
R-5098
13
SR-158
14
R-2314
USE ONLY MANUFACTURED REPLACEMENT PARTS. USE OF ANY OTHER PARTS COULD CAUSE INJURY OR DEATH.
Empire Comfort Systems, Inc. Nine Eighteen Freeburg Ave. Belleville, IL 62222-0529
Page 12
SYMPTOMS - POSSIBLE CAUSES AND CORRECTIONS
DESCRIPTION
CASING SIDE ASSEMBLY - LEFT
CASING BACK
PIEZO IGNITOR
CASING SIDE ASSEMBLY - RIGHT
VALVE BRACKET
GAS VALVE -SIT
MALE CONNECTOR 1/4 TUBE X 3/8
NPT
MALE CONNECTOR 5/16 TUBE X 3/8
NPT (2 REQUIRED)
TUBING - GAS VALVE TO BURNER
TUBING - INLET REGULATOR TO GAS
VALVE
INLET REGULATOR BRACKET
INLET REGULATOR - NAT
INLET REGULATOR - LPG
TUBING - GAS VALVE TO PILOT
ORIFICE HOLDER
d. Pilot flame not surrounding thermocouple - clean pilot, see
Page 9.
e. Inlet gas pressure too low, contact gas supplier.
f. Thermocouple defective - replace.
g. Gas control defective - replace.
4. Main burner does not ignite.
a. Main burner orifice is blocked - clean, see "Main Burner
Flame," Page 9. Attention: The number stamped on the main
burner orifice is a millimeter diameter.
b. Inlet gas pressure too low, contact gas supplier.
5. Heater keeps shutting "OFF" during normal operation.
a. Pilot is blocked - clean pilot, see Page 9.
b. Inlet gas pressure too low, contact gas supplier
Part Description
Type of Gas (Propane or Natural)
SR-10T
INDEX
PART
NUMBER
NUMBER
15
R-2317
15
R-2476
16
R-2331
17
R-5002
18
R-5000
18
R-5006
19
SR-179
20
SR-153
21
R-2305
22
SR-134
23
SR-129
24
SR-135
25
R-1992
26
SR-154
NOT SHOWN
R-5008
NOT SHOWN
SR-216
DESCRIPTION
MAIN BURNER ORIFICE - NAT
MAIN BURNER ORIFICE - LPG
BURNER
THERMOCOUPLE LEAD
PILOT/THERMOCOUPLE ASSEMBLY
(LPG ONLY)) (INCLUDES ITEM #17)
PILOT/THERMOCOUPLE ASSEMBLY
(NAT ONLY)) (INCLUDES ITEM #17)
PILOT BRACKET
ORIFICE SHIELD
CHROME GRILL
CASING LOUVER (2 REQUIRED)
REFLECTOR ASSEMBLY
HEAT SHIELD
BULB CLIP
OPTIONAL SRS-10 FLOOR STAND
KIT
IGNITOR WIRE
HARDWARE PACKAGE
R-5210