- ページ 6

プールフィルター Jandy Jandy Pro SeriesのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Jandy Jandy Pro Series 20 ページ。 Single element cartridge pool & spa cs filters
Jandy Jandy Pro Series にも：オーナーズマニュアル (12 ページ), インストレーション・マニュアル (16 ページ), 設置および操作マニュアル (20 ページ), マニュアル (8 ページ), クイック・スタート・マニュアル (2 ページ), 設置および操作マニュアル (20 ページ), インストレーション・インストラクション (2 ページ), 設置および操作マニュアル (16 ページ), 設置および操作マニュアル (16 ページ), 設置および操作マニュアル (16 ページ)

Page 6

A standard 1.5" plastic wall / return fi tting (not included) must be

installed so that the top edge of the underwater light's lens is at least 4

inches (10.2 cm) below the surface of the water in the pool.

See Figure 1.

NOTE: For optimal lighting results it is recommended to place lights 12-18"

below the water line.

NOTE: To be certain that the pool's electrical system meets all applicable

requirements, the electrician should also consult the local building

department.

12 VAC Class 2 Magnetic

Transformer or

Junction Box

Rigid 1" electrical conduit. Sweep

elbows only, no 90º elbows.

NOTE: Verticle installations such as bench and walk-out locations will use ALL of the same clearance requirements.

The light face must be completely snug with the light fitting without any protrusion from the light fixture.

Figure 1.

Jandy

Plastic Fitting

Use the chart below to determine the appropriate pipe length for your

installation.

WATTS

12W

24W

All products listed above come in a variety of cord lengths. Cord lengths

Table 1.

Jandy

ENGLISH

48" min.

Check AHJ for other J-box requirements

Pro Series LED Light Installation with Standard 1.5"

MINIMUM LENGTH FOR 1.5" PIPE

come in 50, 100 & 150 feet lengths.

Pro Series LED Light Minimum 1.5" pipe length

Nicheless Underwater LED Lights | Owner's Manual

8" minimum to maximum water level

Maximum possible water line.

(top of copping)

4" minimum to top of lens

1.5" pipe. Length requirement varies

by model. (See Table 1)

10"