- ページ 7

IP電話 Avaya 4600 SeriesのPDF 接続をオンラインで閲覧またはダウンロードできます。Avaya 4600 Series 14 ページ。 Infrared dialing
Avaya 4600 Series にも：設置および安全に関する指示 (11 ページ), 安全上のご注意 (11 ページ), 製品情報 (2 ページ), マニュアル (4 ページ)

• Disabled — The port has been configured not to supply power.

• FAULT — The port is in error.

Profile

The Profile that has been selected for a port. This can take one of the following values:

• Guaranteed — The device on the port has power reserved for it, as listed in the Limited

To column.

• Not Guaranteed — The device on the port has no power reserved for it. It will receive

power if the switch is below its maximum power budget, and all ports with higher

priorities are receiving power.

Limited To

The power that has been guaranteed to a device. If no power has been guaranteed, a hyphen

('-') is displayed and the port is limited to 15.4 watts as defined in the Power over Ethernet

specification (IEEE 802.3af-2003).

Current

The power that is currently supplied to a port. If no power is currently supplied, a hyphen ('-')

is displayed.

Peak

The maximum power that has been supplied by a port since the counter was last reset.

The following example can be used to verify that the switch can auto-detect the PDs and

supply power to them.

• Plug the Avaya 4620, 4612 and 4602SW IP phones into ports 1-3.

• Click Refresh as shown in Figure 5. Figure 6 shows that all three IP telephones are

automatically powered up, and the power status is changed to Active. Note that the

Current and Peak power for all three IP telephones are displayed also.

SZ; Reviewed:

WCH 3/19/2004

Solution & Interoperability Test Lab Application Notes

7 of 14

3com-PoE-Config.doc