- ページ 6

ドリル Makita 6010BVRのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Makita 6010BVR 8 ページ。
Makita 6010BVR にも：取扱説明書 (16 ページ)

ASSEMBLY

1. Tighten

2. Chuck key

1. Tighten

2. Sleeve

3. Ring

OPERATION

CAUTION:

•

Always be sure that the tool is switched off and unplugged before

carrying out any work on the tool.

Installing or removing drill bit

For tool with standard keyed chuck

004643

To install the bit, place it in the chuck as far as it will go. Tighten the chuck by

hand. Place the chuck key in each of the three holes and tighten clockwise. Be

sure to tighten all three chuck holes evenly.

To remove the bit, turn the chuck key counterclockwise in just one hole, then

loosen the chuck by hand.

After using the chuck key, be sure to return to the original position.

For tool with keyless chuck

004650

Hold the ring and turn the sleeve counterclockwise to open the chuck jaws.

Place the bit in the chuck as far as it will go. Hold the ring firmly and turn the

sleeve clockwise to tighten the chuck.

To remove the bit, hold the ring and turn the sleeve counterclockwise.

Drilling operation

Drilling in wood

When drilling in wood, the best results are obtained with wood drills equipped

with a guide screw. The guide screw makes drilling easier by pulling the bit

into the workpiece.

Drilling in metal

To prevent the bit from slipping when starting a hole, make an indentation with

a center-punch and hammer at the point to be drilled. Place the point of the bit

in the indentation and start drilling.

Use a cutting lubricant when drilling metals. The exceptions are iron and brass

which should be drilled dry.