Makita 6010BVR Kullanım Kılavuzu - Sayfa 6
Matkap Makita 6010BVR için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Makita 6010BVR 8 sayfaları.
Ayrıca Makita 6010BVR için: Kullanım Kılavuzu (16 sayfalar)
Sayfayı Yazdır
ASSEMBLY
2
1
1. Tighten
2. Chuck key
1
1. Tighten
2. Sleeve
3. Ring
OPERATION
6
CAUTION:
•
Always be sure that the tool is switched off and unplugged before
carrying out any work on the tool.
Installing or removing drill bit
For tool with standard keyed chuck
004643
To install the bit, place it in the chuck as far as it will go. Tighten the chuck by
hand. Place the chuck key in each of the three holes and tighten clockwise. Be
sure to tighten all three chuck holes evenly.
To remove the bit, turn the chuck key counterclockwise in just one hole, then
loosen the chuck by hand.
After using the chuck key, be sure to return to the original position.
For tool with keyless chuck
004650
Hold the ring and turn the sleeve counterclockwise to open the chuck jaws.
Place the bit in the chuck as far as it will go. Hold the ring firmly and turn the
2
sleeve clockwise to tighten the chuck.
To remove the bit, hold the ring and turn the sleeve counterclockwise.
3
Drilling operation
Drilling in wood
When drilling in wood, the best results are obtained with wood drills equipped
with a guide screw. The guide screw makes drilling easier by pulling the bit
into the workpiece.
Drilling in metal
To prevent the bit from slipping when starting a hole, make an indentation with
a center-punch and hammer at the point to be drilled. Place the point of the bit
in the indentation and start drilling.
Use a cutting lubricant when drilling metals. The exceptions are iron and brass
which should be drilled dry.