ページを印刷する
EN
GARDENA Pressure Sprayer 5L Plus
Translation of the original instructions.
Please read the operating instructions carefully and observe the notes
given. Use the instructions to familiarise yourself with the Pressure Sprayer,
its proper use and the notes on safety. For safety reasons, children under
16 as well as persons not familiar with these operating instructions must not
use the Pressure Sprayer. Never operate the product when you are tired,
ill or under the influence of alcohol, drugs or medicine.
Read the operator's manual carefully before use and keep for future
reference.
Intended use:
The GARDENA Pressure Sprayer is intended for distributing solvent-free
liquid pesticides
1)
, herbicides
1)
, fertilisers
wax
1)
in domestic gardens and allotments. It must not be used in public
places, parks, sport arenas, or in agriculture or forestry. Compliance with
the specifications in this operating manual is a requirement for the proper
use of the Pressure Sprayer.
1)
According to the Plant Protection Law as well as the Detergents and Cleaning Agents Law, only
approved agents may be used (authorised specialist dealers).
Please note:
Due of the risk of physical injury, the GARDENA Pressure Sprayer must not
be used for spraying substances other than those specified by GARDENA.
Also, no acids, disinfectants or impregnators, aggressive and solvent-con-
taining cleaning agents, petrol or spray oil may be sprayed.
1. SAFETY
Danger of physical injuries:
Never open the Pressure Sprayer or unscrew the nozzle and the dosing cap
when the Pressure Sprayer is still pressurised. To prevent injury, never con-
nect the Pressure Sprayer to an air-compressor.
Always hold the Pressure Sprayer upright before the safety relief valve
(Fig. O1) is pulled.
When spraying insecticides, herbicides and fungicides or other liquid plant
protection products, you must comply with all special precautionary meas-
ures specified by the manufacturer of the product you are using.
Before each opening of the Pressure Sprayer, thoroughly release
pressure by pulling the safety relief valve
DANGER! Small parts can be easily swallowed. There is also a risk that the
polybag can suffocate toddlers. Keep toddlers away when you assemble
the product.
Operation:
CAUTION: The tank may only be filled with a maximum of 5 litres
liquid. Inspect the Pressure Sprayer visually before each use. Never leave
your Pressure Sprayer unattended or for long periods when full and pres-
surised. Keep the unit out of the reach of children. You are responsible for
the safety of others. Keep your Pressure Sprayer away from heat sources
and hot environments. Screw on the pump handle
not use tools) and ensure that the O-ring
Cleaning:
Release the pressure after each use, empty the container, clean it carefully
and rinse with clear water. Then leave the pressure sprayer open and allow
it to dry. Do not dispose of residual fluids in the sewerage system (local
disposal systems). Always clean the Pressure Sprayer before using a dif-
ferent product to avoid chemical reactions. When using several Pressure
Sprayers, the tanks and spray nozzle may not be exchanged between
them. We recommend that you have your Pressure Sprayer thoroughly
inspected (preferably at a GARDENA Service Centre) after using it for
5 years.
Storage:
Before storing, loosen the tank cap and always empty your Pressure
Sprayer completely (also after cleaning with water). Store away from frost.
If you use the permanent lock
(13)
very carefully.
Carry the pressure sprayer by the carrying strap
Make sure that the product is protected from direct sunlight.
The product may heat up.
2. ASSEMBLY
1. Fig. A1: Slide the spray lance
the union nut
(3)
.
4
1)
, window cleaners
1)
, and car
(9)
.
(10)
tightly by hand (do
(15)
(Fig. O1) is positioned correctly.
(Fig. O3) pay attention that you work
(8)
(10)
or the handle
(1)
into the hand valve
(2)
and screw on
2. Fig. A2: Slide the spray hose
union nut
(5)
.
3. Fig. A3: Slide the spray hose
(7)
union nut
.
4. Fig. A4: Attach the carrying strap
3. OPERATION
Please observe the safety and proportioning instructions provided by the
manufacturer of the product you are going to spray.
To spray the liquid [Fig. O1/O2/O3 ]:
1. Pull the safety relief valve
2. Unscrew the pump handle
container
(6)
.
3. If necessary, fill in an additive via the dosing cap
(Scale with 5, 10 and 20 ml).
4. Screw the pump handle
container
(6)
.
5. If necessary, loosen the union nut
length.
6. Release the locking device
two stops of the thread
7. Pump with the pump handle
8. Adjust the spray jet (clockwise rotation v spray mist; counterclockwise
rotation v spray jet) and the spray angle via the nozzle
9. Push the button
(12)
you can lock the button
4. MAINTENANCE
To clean the pressure sprayer:
Always clean your Pressure Sprayer after spraying. Use the Pressure
Sprayer only with clear water (possibly with addition of dish detergent) and
spray empty. The valves, the spray lance
are cleaned. In the case of outer dirtying of cover and tank, thoroughly clean
the area thread and thread-O-ring
Check the safety relief valve
5. STORAGE
To put into storage:
1. Clean the pressure sprayer (see 4. MAINTENANCE).
2. Store the pressure sprayer in a frost-free place.
(9)
6. TROUBLESHOOTING
To clean the filter [ Fig. T1 ]:
v Unscrew the spray lanze
Problem
Pump does not build up
pressure
Pressure Sprayer does not
spray although there is
sufficient pressure or only
sprays with a weak spray jet
It is difficult to open and
close the container
NOTE: For any other malfunctions please contact the GARDENA
service department.
7. TECHNICAL DATA
Max. capacity
Spray tube length
Permissible working pressure
Max. permissible operating temperature
.
8. SERVICE / WARRANTY
In the event of a warranty claim, no charge is levied to you for the services
provided.
GARDENA Manufacturing GmbH offers a two-year warranty (effective as
of the date of purchase) for this product. This warranty includes all signifi-
(4)
into the hand valve and screw on the
(4)
into the container and screw on the
(8)
to the container
(9)
.
(10)
or the dosing cap
(18)
and fill the
(18)
.
(10)
or the dosing cap
(18)
back onto the
(3)
and adjust the lance to the desired
(17)
on the pump handle until it is between the
(15)
.
(10)
.
on the lance handle to spray the liquid. If necessary,
(12)
(13)
with the permanent lock
(1)
, the nozzle
(15)
.
(9)
for smooth running.
(1)
, remove the filter
(14)
and clean it.
Possible Cause
Remedy
(10)
(18)
Handle
or the dosing cap
v Screw on handle
too lightly screwed on.
dosing cap
Hose connection at the
v Tighten the hose connec
container and hand valve
tions at the container and
is not tight.
hand valve.
(13)
Permanent lock
on the
v Release the permanent
handle is locked.
lock
(16)
Sealing cap
is dirty /
v Clean / exchange sealing
defective.
cap
(11)
Nozzle
is blocked.
v Unscrew nozzle
clean.
(14)
Filter
is clogged.
v Remove filter
spray lance and clean it.
Container pressure too high.
v Release the container
pressure completely
by means of the safety
relief valve
(6)
.
(11)
.
.
(11)
and the filter
(14)
(10)
or the
(18)
tighter.
(13)
on the handle.
(16)
.
(11)
and
(14)
from the
(9)
.
5 l
42 – 72 cm
3 bar
40 °C