Gardena 5L Plus Посібник оператора - Сторінка 3

Переглянути онлайн або завантажити pdf Посібник оператора для Фарборозпилювач Gardena 5L Plus. Gardena 5L Plus 5 сторінок.

Друкувати сторінку

GARDENA Pressure Sprayer 5L Plus

Translation of the original instructions.

Please read the operating instructions carefully and observe the notes

given. Use the instructions to familiarise yourself with the Pressure Sprayer,

its proper use and the notes on safety. For safety reasons, children under

16 as well as persons not familiar with these operating instructions must not

use the Pressure Sprayer. Never operate the product when you are tired,

ill or under the influence of alcohol, drugs or medicine.

Read the operator's manual carefully before use and keep for future

reference.

Intended use:

The GARDENA Pressure Sprayer is intended for distributing solvent-free

liquid pesticides

, herbicides

, fertilisers

wax

in domestic gardens and allotments. It must not be used in public

places, parks, sport arenas, or in agriculture or forestry. Compliance with

the specifications in this operating manual is a requirement for the proper

use of the Pressure Sprayer.

According to the Plant Protection Law as well as the Detergents and Cleaning Agents Law, only

approved agents may be used (authorised specialist dealers).

Please note:

Due of the risk of physical injury, the GARDENA Pressure Sprayer must not

be used for spraying substances other than those specified by GARDENA.

Also, no acids, disinfectants or impregnators, aggressive and solvent-con-

taining cleaning agents, petrol or spray oil may be sprayed.

1. SAFETY

Danger of physical injuries:

Never open the Pressure Sprayer or unscrew the nozzle and the dosing cap

when the Pressure Sprayer is still pressurised. To prevent injury, never con-

nect the Pressure Sprayer to an air-compressor.

Always hold the Pressure Sprayer upright before the safety relief valve

(Fig. O1) is pulled.

When spraying insecticides, herbicides and fungicides or other liquid plant

protection products, you must comply with all special precautionary meas-

ures specified by the manufacturer of the product you are using.

Before each opening of the Pressure Sprayer, thoroughly release

pressure by pulling the safety relief valve

DANGER! Small parts can be easily swallowed. There is also a risk that the

polybag can suffocate toddlers. Keep toddlers away when you assemble

the product.

Operation:

CAUTION: The tank may only be filled with a maximum of 5 litres

liquid. Inspect the Pressure Sprayer visually before each use. Never leave

your Pressure Sprayer unattended or for long periods when full and pres-

surised. Keep the unit out of the reach of children. You are responsible for

the safety of others. Keep your Pressure Sprayer away from heat sources

and hot environments. Screw on the pump handle

not use tools) and ensure that the O-ring

Cleaning:

Release the pressure after each use, empty the container, clean it carefully

and rinse with clear water. Then leave the pressure sprayer open and allow

it to dry. Do not dispose of residual fluids in the sewerage system (local

disposal systems). Always clean the Pressure Sprayer before using a dif-

ferent product to avoid chemical reactions. When using several Pressure

Sprayers, the tanks and spray nozzle may not be exchanged between

them. We recommend that you have your Pressure Sprayer thoroughly

inspected (preferably at a GARDENA Service Centre) after using it for

5 years.

Storage:

Before storing, loosen the tank cap and always empty your Pressure

Sprayer completely (also after cleaning with water). Store away from frost.

If you use the permanent lock

(13)

very carefully.

Carry the pressure sprayer by the carrying strap

Make sure that the product is protected from direct sunlight.

The product may heat up.

2. ASSEMBLY

1. Fig. A1: Slide the spray lance

the union nut

(3)

, window cleaners

, and car

(9)

(10)

tightly by hand (do

(15)

(Fig. O1) is positioned correctly.

(Fig. O3) pay attention that you work

(8)

(10)

or the handle

(1)

into the hand valve

(2)

and screw on

2. Fig. A2: Slide the spray hose

union nut

(5)

3. Fig. A3: Slide the spray hose

(7)

union nut

4. Fig. A4: Attach the carrying strap

3. OPERATION

Please observe the safety and proportioning instructions provided by the

manufacturer of the product you are going to spray.

To spray the liquid [Fig. O1/O2/O3 ]:

1. Pull the safety relief valve

2. Unscrew the pump handle

container

(6)

3. If necessary, fill in an additive via the dosing cap

(Scale with 5, 10 and 20 ml).

4. Screw the pump handle

container

(6)

5. If necessary, loosen the union nut

length.

6. Release the locking device

two stops of the thread

7. Pump with the pump handle

8. Adjust the spray jet (clockwise rotation v spray mist; counterclockwise

rotation v spray jet) and the spray angle via the nozzle

9. Push the button

(12)

you can lock the button

4. MAINTENANCE

To clean the pressure sprayer:

Always clean your Pressure Sprayer after spraying. Use the Pressure

Sprayer only with clear water (possibly with addition of dish detergent) and

spray empty. The valves, the spray lance

are cleaned. In the case of outer dirtying of cover and tank, thoroughly clean

the area thread and thread-O-ring

Check the safety relief valve

5. STORAGE

To put into storage:

1. Clean the pressure sprayer (see 4. MAINTENANCE).

2. Store the pressure sprayer in a frost-free place.

(9)

6. TROUBLESHOOTING

To clean the filter [ Fig. T1 ]:

v Unscrew the spray lanze

Problem

Pump does not build up

pressure

Pressure Sprayer does not

spray although there is

sufficient pressure or only

sprays with a weak spray jet

It is difficult to open and

close the container

NOTE: For any other malfunctions please contact the GARDENA

service department.

7. TECHNICAL DATA

Max. capacity

Spray tube length

Permissible working pressure

Max. permissible operating temperature

8. SERVICE / WARRANTY

In the event of a warranty claim, no charge is levied to you for the services

provided.

GARDENA Manufacturing GmbH offers a two-year warranty (effective as

of the date of purchase) for this product. This warranty includes all signifi-

(4)

into the hand valve and screw on the

(4)

into the container and screw on the

(8)

to the container

(9)

(10)

or the dosing cap

(18)

and fill the

(18)

(10)

or the dosing cap

(18)

back onto the

(3)

and adjust the lance to the desired

(17)

on the pump handle until it is between the

(15)

(10)

on the lance handle to spray the liquid. If necessary,

(12)

(13)

with the permanent lock

(1)

, the nozzle

(15)

(9)

for smooth running.

(1)

, remove the filter

(14)

and clean it.

Possible Cause

Remedy

(10)

(18)

Handle

or the dosing cap

v Screw on handle

too lightly screwed on.

dosing cap

Hose connection at the

v Tighten the hose connec

container and hand valve

tions at the container and

is not tight.

hand valve.

(13)

Permanent lock

on the

v Release the permanent

handle is locked.

lock

(16)

Sealing cap

is dirty /

v Clean / exchange sealing

defective.

cap

(11)

Nozzle

is blocked.

v Unscrew nozzle

clean.

(14)

Filter

is clogged.

v Remove filter

spray lance and clean it.

Container pressure too high.

v Release the container

pressure completely

by means of the safety

relief valve

(6)

(11)

and the filter

(14)

(10)

or the

(18)

tighter.

(13)

on the handle.

(16)

(11)

and

(14)

from the

(9)

5 l

42 – 72 cm

3 bar

40 °C