- ページ 2

電動工具 Ceyear 6481 SeriesのPDF クイックマニュアルをオンラインで閲覧またはダウンロードできます。Ceyear 6481 Series 6 ページ。 Optical fiber fusion splicer

ページを印刷する

This carry-around Quick Guide briefly introduces the basic functions and operating methods of the

instrument. For detailed instructions, please read the User Manual.

Before using this product, be sure to read this guide carefully, and remember to keep this guide properly

while carrying it around, so as to use and maintain this product properly by reading the guide at any time.

Description of Buttons

Arrow button - Up

Move cursor/adjust gap

Arrow button - Left

Move cursor leftwards/decrease

the parameter

"Enter" button

Confirm selection/clean

discharge

Arrow button - down

Move cursor downwards/alignment

Menu button

Go to main menu/back

Discharge Correction

If the altitude is higher or the temperature changes a lot, the discharge correction shall be performed

before fusion. Discharge correction is used to optimize the discharge arc position and current size

according to the following steps:

1. Place a standard single-mode fiber with well-prepared cross-section into the fusion splicer.

2. In the menu, select [Maintenance] → [Discharge] → [Discharge Correction] and press [Enter] button

to start the discharge correction.

3. Fusion splicer automatically discharge, correct the arc position and adjust current size. If the

calibration is not successful, replace the two test fibers with the well-finished cross-sections

according to the instructions, and perform another discharge arc calibration.

6481 Series Optical Fiber Fusion Splicer

Quick Guide

Arrow button - Right

Move cursor rightwards/increase the

parameter

Power button

On/OFF

ARC button

Discharge

Heating button

Start, stop heating

Reset button.

Return to standby

Auto button

Automatically start fusion /

enter the software upgrade

state in conjunction with

power button

X/Y button

XY view switching