- ページ 5
アクセサリー A&E Systems WeatherPro Oasis EliteのPDF 診断サービスマニュアルをオンラインで閲覧またはダウンロードできます。A&E Systems WeatherPro Oasis Elite 14 ページ。
ページを印刷する1.5
Wire To Remote Switch
The remote switch is connected to the control
box with three (3) 16 gauge wires. These are
Brown, Yellow, Green for WeatherPro and Brown/
White, Yellow/White, Green/White for Oasis Elite.
The switch end of the wire will be connected to
the switch by means of 1/4" insulated tab con-
nectors. The control box end has a pig tail to
connect the control box to these three wires. See
switch for correct wiring. Make sure connections
are tight and corrosion free.
FIG. 1.5
Green
Brown
Yellow
Pig Tail to
Remote Switch
Green
Yellow
Brown
EXTEND
Awning
Control
RETRACT
1.6 Wind Sensor Cable
The wind sensor is connected to the control box
with a FLAT four (4) conductor cable terminated
on both ends with an RJ-11 telephone connec-
tor. Maximum length is 18'. This cable is polarity
sensitive and must be assembled as shown. A
standard telephone cable will not work. Cable
can be checked with a Dometic 3107127.007
cable tester. If cable is found to be defective re-
place with a cable no longer than 18'
WeatherPro
EXTEND
Remote
Switch
RETRACT
Pig Tail to
Remote Switch
Green/ White
EXTEND
RETRACT
Yellow/White
Oasis Elite
Remote
Switch
FUSE INSIDE
FIG. 1.6
4 Conductor
FLAT Cable
Connections
FIG. 1.6 cont.
Flat Four Conductor Cable
1.7 Ignition Interlock Wire
The ignition Interlock wire when correctly installed
will prevent the awning from opening when the
ignition key is in the on position. This wire is routed
between the ignition isolator (Pink) wire of the
control box to the ignition isolator of the vehicle.
It should be a 16 gauge wire. Make sure wire
connections are tight and corrosion free.
FIG. 1.7
EXTEND
RETRACT
5
Pin 1
RJ-11 Connector
Pink
Awning
Control
FUSE INSIDE
+ Ignition
Isolator