- ページ 3

フィットネス機器 Align-Pilates Ladder Barrel Mk IIのPDF 組立説明書をオンラインで閲覧またはダウンロードできます。Align-Pilates Ladder Barrel Mk II 8 ページ。

4. Assembly Instructions



Take out the side panels and lay on a soft surface so as not to scratch the wood. Attach the side

panels to the barrel top using x 3 medium bolts with Loctite washers and nut, ensure a washer is

used on each side - the nut goes on the inside of the barrel (Fig. 1 & Fig. 2). Do not fully tighten the

nuts as this will prevent you being able to insert the barrel connecting poles later in the assembly.



Insert the x2 short barrel connecting poles into the holes of the side panels. Use x 4 medium bolts

and washers and screw these in until hand tight (x 2 on each side) (Fig. 3). You can now tighten the

x6 medium bolt, washer and nut attaching the side panels to the barrel top.



Next, attach the black metal runners. Place the runners on the inside of the barrel with the side with

4 holes next to the wooden panel. It will become obvious which runner is for which side. First use

the x 2 long bolts (use a washer on both sides) and thread them through from the outside of the

barrel and do the nuts up hand tight.



Then screw in the remaining x 2 medium bolts + washers, then tighten all bolts and repeat for the

other side – see Fig 4 & Fig 5 below.

Fig.1

Fig. 2

Fig. 3