- ページ 11

エアクリーナー Alive Air Air PurifierのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Alive Air Air Purifier 17 ページ。 Alive air 9-stage air purifier owner’s manual
Alive Air Air Purifier にも：オーナーズマニュアル (17 ページ)

ページを印刷する

CLEANING AND MAINTENANCE ( Cont. )

Cleaning and Maintenance of Washable Pre-Filter & Electronic Grid (Cont.)

4. Cleaning the Washable Pre-Filter & Electronic Grid

Put a very small amount of Dish Detergent such as Dawn

Please do not clean using acidic or alkaline detergent that can create rust on the surface of device.

Place the two washable filters in the bathtub

Fill the tub with warm water (not hot) to just cover the filters

Soak

(Do

NOT

Scrub)

the two filters for a good half hour to remove dust and grime

Drain the tub and rinse the filters under the shower head. Though the faceplate

does not need soaking, rinse both sides with the shower head as well.

Please take care not to damage any wiring while cleaning the electronic grid

If any electrical discharge wire is broken, the device will lose part or

all of its dust collecting capability.

Any broken wires should be thrown away instead of being left inside the unit.

Otherwise, a dangerous short-circuit or high-voltage sparks may occur.

Please contact

[email protected]

5. Air Dry

ONLY

all washed parts.

Air dry the pre-filter, electronic grid and faceplate overnight. Operating

a wet unit may cause electrical shock or malfunction.

If the front cover of the electronic grid is not properly installed,

the unit will not function.

Please make sure the plastic wrap for the electrical discharge wire

is located in its proper position.

ONLY

if using AUTO SETTING, a New 'Clean Air Reference' is required after cleaning

Every time you remove the faceplate to clean the unit, if there is a power outage, or you power it off, or if you unplug the unit for

any reason, you will have to re-program a 'reference for clean air' if you are leaving your machine on AUTO.

This is the case because any memorized content will have been completely erased. See page 6 for instructions on resetting

the auto-sensor.

Electronic Grid Wire Replacement

It's unusual to break a grid wire if properly following the above instructions for cleaning the Electronic Grid. But, if it does happen, call

(800) 215-1689 to order a replacement wire(s).

~ CAUTION: The grid wire and spring ends may have sharp edges. Please, handle them with care. ~

The Electronic Grid should have 3 wires extending from a bottom 'hook', around the top and back down to another 'hook'. Place one spring

end on a bottom hook.

Wrap the wire with it's plastic coated center around the 3 pegs near the top of the grid assembly. Gently stretch the wire just enough to

place the spring end over the hook at the lower end of the grid assembly.

For additional visual instructions, see "Plasma Grid Wire Replacement" illustration at

http://aliveairpurifier.com/wp-content/uploads/2009/09/plasma-wire1.jpg

Alive Air 9-Stage Air Purifier Owner's Manual

[

NOT

for additional electrical discharge wire.

Do NOT

operate your air purifier until you've received and replaced the broken wire(s).

automatic dishwasher detergent]

Plastic Wrap

in the bathtub.