- ページ 4
浄水器 AlkaWay HB-H04のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AlkaWay HB-H04 6 ページ。 Hydrogen pod, generator water bottle
ページを印刷するpressure so that waste Ozone (O
12. Attaching a drinking water bottle.
a. Choose a suitable bottle adaptor ring that matches the thread on the bottle neck.
b. Screw to the bottle adaptor ring into the top of the base firmly. Use the generator
cover on its edge, aligning its edge with the notches in the bottle adaptor ring and
tighten (refer to image above).
c. Fill bottle with good quality (filtered) drinking water to just below the bottles
thread.
d. Screw the generator base unit onto the bottle check for leaks.
e. Turn over the assembly so the base unit is beneath the bottle (refer the image
above).
f. Then follow instruction number 6 above to start the hydrogen generator.
Maintenance Method
• Daily cleaning: Rinse inside of bottle with water. Fill half full and shake vigorously. Pour
off water leaving a small amount in bottom covering the electrode plate, then replace
rubber plug and screw on glass bottle.
• Periodic cleaning: Use citric acid to clean the electrode plates. These plates are located
in the top of the base unit. Over time these plates collect mineral deposits and scale.
To clean, fill bottle half way and drop in 5 grams of citric acid, allow to soak for 2 hours,
shake several times and pour off dirty water. Rinse again with clean water.
• Odour treatment: After long periods of use the bottle may give off an odour. Pour in
60°C to 70°C hot water and soak for 5 minutes to eliminate. DO NOT use water over
80°C in the bottle.
• DO NOT POUR BOILING WATER INTO THE GLASS BOTTLE IT WILL DAMAGE OR BREAK
THE GLASS.
• DO NOT clean glass bottle with detergents or volatile solvents. Mild soap and water
work best to clean the glass bottle.
• DO NOT soak the base unit in water. It contains electrical components that can be
damaged by immersing in water.
I:\PRODUCTS\Hydrogen Pod\Warehouse\Hydrogen Pod Manual A4 V2.docx
) and Chlorine (CL) can be discharged as a gas.
3
4