- ページ 10
船舶用GPSシステム Garmin GPS 17 SeriesのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Garmin GPS 17 Series 16 ページ。 Technical specifications
Garmin GPS 17 Series にも： 取付説明書 (17 ページ), 取付説明書 (19 ページ), 技術仕様 (37 ページ)
ページを印刷する
I
I
NSTALLATION
NSTRUCTIONS
Power/Data Cable Wiring
The following pages contain several wiring diagrams. The first diagram on the next page is a simple diagram showing the GPSMAP 2106/2110
MFD using the 18-pin Power/Data wiring harness and the GPS 17. If two GPSMAP 2106/2110 units are installed and connected, only one
GPS 17 antenna needs to be installed. Next are wiring diagram examples showing the GPSMAP 2106/2110 using the 18-pin Power/Data
wiring harness interfacing with a variety of different equipment. Refer to the wiring diagram that best suits your needs. For third-party devices,
refer to the wiring guidelines included with that equipment. Use 22 AWG (18 AWG for the Red and Black wires), shielded, twisted-pair wiring
for extended runs of wire. Solder all connections and seal the connection with heat shrink tubing. If networking two MFDs, the GPS 17 and
NMEA input devices should only be attached to one MFD. A pinout of the cable is shown below.
Power/Data Cable Input/Output Ports
The GPSMAP 2106/2110 Power/Data cable has four I/O (Input/Output) ports.
Ports 1 and 2—communicate with other NMEA-compliant devices, such as VHF radios, NMEA instruments, autopilots, or PCs (Port 1 only).
You can input one NMEA device to each port, and output in parallel to three NMEA devices per port.
Port 3—is reserved for use with Garmin sounder modules.
Port 4—is reserved for use with the Garmin GPS 17 GPS/WAAS antenna.
The following formats are supported for connection of external devices: Garmin proprietary sonar module and NMEA 0183 version 3.01. The
following are the sentences for NMEA 0183, version 3.01 and later output:
Approved sentences—GPBWC, GPRMC, GPGGA, GPGSA, GPGSV, GPGLL, GPBOD, GPRMB, GPRTE, GPVTG, GPWPL, and GPXTE.
Garmin proprietary sentences—PGRME, PGRMM, PGRMZ, and PSLIB.
The unit also includes NMEA input with support for the WPL sentence, DSC, and sonar NMEA input with support for the DPT (Depth) or
DBT, MTW (Water Temp), and VHW (Water, Speed, and Heading) sentences. The unit interface must be set to NMEA In/NMEA Out.
Documentation concerning NMEA and RTCM formats
and sentences are available for purchase from:
National Marine Electronics Association (NMEA)
Seven Riggs Avenue
Severna Park, MD 21146
U.S.A.
www.nmea.org
8
PIN #
COLOR
1
N/C
2
N/C
3
N/C
4
WHITE/BROWN
5
WHITE/BLUE
6
ORANGE
7
N/C
8
N/C
9
VIOLET
10
GRAY
11
YELLOW
12
N/C
13
WHITE
14
GREEN
15
RED
16
BROWN
17
BLUE
18
BLACK
2
1
4
3
6
5
8
7
11
10
9
12
15
14
13
18
17
16
Cable End View
FUNCTION
PORT 3 DATA IN
PORT 3 DATA OUT
ACCESSORY ON
PORT 2 DATA IN
PORT 2 DATA OUT
ALARM LOW
PORT 4 DATA IN
PORT 4 DATA OUT
DC POWER INPUT
PORT 1 DATA IN
PORT 1 DATA OUT
GROUND (POWER/DATA)
GPSMAP 2106/2110 & GPS 17