- ページ 8

船舶用GPSシステム Garmin GPS 17 SeriesのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Garmin GPS 17 Series 16 ページ。 Technical specifications
Garmin GPS 17 Series にも：取付説明書 (17 ページ), 取付説明書 (19 ページ), 技術仕様 (37 ページ)

ページを印刷する

1. Wiring and Cables

NSTALLATION

NSTRUCTIONS

Wiring and Cables

The GPSMAP 2106/2110 comes with an 18-pin Power/Data cable. For some installations, it may be necessary to drill 1.25" (31.7 mm) holes to

route the connector end of the cables. Garmin rubber grommets are provided to cover the installation holes (see below). Wiring instructions are

found on the following pages. If you experience difﬁculty installing the unit, contact an installation professional.

The grommets may not be needed in some installations. The grommets do NOT create a waterproof seal. Apply a marine sealant after

installation to weatherproof around the grommet and cable. Additional grommets can be purchased from your Garmin dealer or direct from

Garmin. Be sure to test the system before installing the grommets.

Tools

• Drill

• 1.25" (31.7 mm) paddle drill bit or hole saw

• Pencil

• Utility knife

• Marine sealant (optional)

To install the cable grommet:

1. Mark the location where the Power/Data cable is to route through.

2. Using a 1.25" (31.7 mm) paddle drill bit or hole saw, drill the installation hole.

3. Refer to the diagram below for trimming instructions. Carefully trim the cable hole, as needed.

4. Route the cable to the unit.

5. Spread the grommet apart at the split, and place it around the cable (see below).

6. Firmly push the grommet into the installation hole until it is seated. Apply marine sealant, as needed, to weatherproof the cable.

Use this hole (no trim) for the

Power/Data, or GPS 17 cable

Split

GPSMAP 2106/2110 & GPS 17