- ページ 5

船舶用GPSシステム Garmin GPS 190-01219-91のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Garmin GPS 190-01219-91 36 ページ。 Chartplotter

to connect the wiring harness to a nMEa 0183 device:
1. For Garmin devices, the ground (black) wires serve as NMEA 0183 ground and must be attached together or on the same terminal as the
NMEA 0183 ground on your NMEA 0183 device. Refer to the wiring diagram of your NMEA 0183 device for wire identification.
2. Connect the blue (NMEA 0183 port 1 out) wire from the GPS 152H wiring harness to the NMEA 0183 in (or Rx/A +) wire on the wiring
harness of the NMEA 0183 device, and the brown (NMEA 0183 port 1 in) wire to the NMEA out (or Tx/A +) wire on the wiring harness of the
NMEA 0183 device.
3. Repeat step 2 using the blue and white wires for an additional NMEA 0183 device.
4. Set the serial port(s) on the GPS 152H to use NMEA 0183 data. See the GPS 152H Owner's Manual for more information.
Connecting the Wiring Harness to an optional Horn, Lamp, or Both
The GPS 152H device can be used with a lamp, a horn, or both, to sound or flash an alert when the device displays a message. The alarm does
not need to be wired for the GPS 152H to function. The alarm circuit switches to a low-voltage state when the alarm sounds. It is necessary to
install a relay that limits the current from the device to 100 mA. To manually toggle visual and audible alerts, install single-pole, single-throw
switches.
© 2010 Garmin Ltd. or its subsidiaries
All rights reserved. Except as expressly provided herein, no part of this manual may be reproduced, copied, transmitted, disseminated, downloaded or stored in any storage
medium, for any purpose without the express prior written consent of Garmin. Garmin hereby grants permission to download a single copy of this manual onto a hard drive or
other electronic storage medium to be viewed and to print one copy of this manual or of any revision hereto, provided that such electronic or printed copy of this manual must
contain the complete text of this copyright notice and provided further that any unauthorized commercial distribution of this manual or any revision hereto is strictly prohibited.
Information in this document is subject to change without notice. Garmin reserves the right to change or improve its products and to make changes in the content without
obligation to notify any person or organization of such changes or improvements. Visit the Garmin Web site (www.garmin.com) for current updates and supplemental
information concerning the use and operation of this and other Garmin products.
Garmin
and the Garmin logo are trademarks of Garmin Ltd. or its subsidiaries, registered in the USA and other countries. These trademarks may not be used without the
®
express permission of Garmin.
GPS 152H Installation Instructions
GPS 152H device
Wiring a GPS 152H Device to a Horn, a Lamp, or Both
+
Battery
10–0 Vdc
Wire color
Fuse
1.5 A
Red
Black (ground)
Relay
100 mA max
Yellow (alarm)
coil current
-
Lamp
Horn
5