- ページ 15

船舶用GPSシステム Garmin GPSMAP 17のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Garmin GPSMAP 17 19 ページ。 Gps receiver/antenna
Garmin GPSMAP 17 にも：取付説明書 (16 ページ), 取付説明書 (12 ページ), インストレーション・マニュアル (16 ページ), リファレンス・マニュアル (1 ページ), テクニカル・リファレンス (30 ページ), 取付説明書 (17 ページ), 適合宣言 (1 ページ), 技術仕様 (40 ページ), クイック・スタート・マニュアル (16 ページ)

Final Wiring Connection

After all the wiring is complete, the cables are attached on the back of the GPSMAP 3006C/3010C MFD. If the MFD is not being networked,

be sure to ﬁrmly afﬁx the weather cap over the open connector to limit corrosion of the contacts. The connection ports are labeled on the back

of the MFD.

To install the Power/NMEA, Marine Video, and Network Cables:

1. Align the notch and locking ring tab on the black Power/NMEA cable with the black POWER/NMEA port on the back of the unit. Carefully

press the cable in until it is ﬁrmly seated. Do not force the cable, as this may damage the pins!

2. After the cable is seated, turn the locking ring clockwise until it stops.

3. Repeat steps 1 and 2, attaching the gray Marine Video cable to the gray VIDEO port on the back of the unit.

4. If networking the MFD with the Garmin Marine Network, insert the RJ-45 connector into the NETWORK port on the back of the unit and

screw the locking ring in clockwise until it is ﬁrmly seated.

With power applied to the circuit, test the installation by pressing the POWER key on the front of the unit. See the GPSMAP 3006C/3010C

Owner's Manual for steps on initializing the receiver.

GPSMAP 3006C/3010C & GPS 17

GPSMAP 3006C

Connection ports

GPSMAP 3010C

Connection ports

NSTALLATION

NSTRUCTIONS