おもちゃ Alkem HOのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Alkem HO 4 ページ。 Scale concrete coal dock

ページを印刷する

Roberts and Schaefer Cinder Conveyor

List of parts:

1 set of laser cut acrylic parts

1 sheet of photoetched brass parts (labeled s heet C)

1 Eight inch long, 0.015 inch diameter phosphor bronze rod

Recommended tools and supplies

• XActo knife with sharp number 11 blade

• Plastruct Bondene ABS, Weld or other acrylic glue

• CAA glue (Gap Filling Superglue)

• Fine wet sandpaper (400 or 600 grit)

• Tweezers

• Lycra or fuzz free thread

• Primer- white or grey

• Paints - acrylic or enamels: Concrete, Flat Black, Medium Gray,

Steel and weathering colors such as burnt sienna and burnt um-

ber

• Masking Tape

• Optional Solder iron, ﬂux and silver solder.

1. General Overview

This kit combines precision laser cut acrylic and photo etched

brass parts to make a highly detailed model of the Roberts and

Schaefer Cinder Hoist.

HO Scale

Concrete Coal Dock

Instruction Manual

An experienced modeler should expect to spend about 3 to

4 enjoyable hours for assembly and painting. If you have any

questions please contact us at [email protected]

Figure 1: Assemble the main truss tow-

er of the cinder conveyor.

Insert the ﬂoor using tabs to locate it

properly. When assemble the main truss,

make sure the gusset plates face in with

the raised detail facing out.

Gusset Plates

Figure 2: Add the

side shed to the head

house

Bend the walls, ﬂoor

and roof on the side

shed. Insert the tabs

into the slots on the

head house of the

main truss cinder con-

veyor.

Figure 3: Add the roof and guide

rails

Bend the roof slightly and add to

the top of the cinder conveyor. In-

sert the guide rails to the inside of

the main truss. The vertical portion

of the guide should be centered on

the side of the truss.

Guide

rails

Center guide rails on these sides

Bend