Alkem HO Інструкція з експлуатації
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Іграшка Alkem HO. Alkem HO 4 сторінки. Scale concrete coal dock
Друкувати сторінкуRoberts and Schaefer Cinder Conveyor
List of parts:
1 set of laser cut acrylic parts
1 sheet of photoetched brass parts (labeled s heet C)
1 Eight inch long, 0.015 inch diameter phosphor bronze rod
Recommended tools and supplies
• XActo knife with sharp number 11 blade
• Plastruct Bondene ABS, Weld or other acrylic glue
• CAA glue (Gap Filling Superglue)
• Fine wet sandpaper (400 or 600 grit)
• Tweezers
• Lycra or fuzz free thread
• Primer- white or grey
• Paints - acrylic or enamels: Concrete, Flat Black, Medium Gray,
Steel and weathering colors such as burnt sienna and burnt um-
ber
• Masking Tape
• Optional Solder iron, flux and silver solder.
1. General Overview
This kit combines precision laser cut acrylic and photo etched
brass parts to make a highly detailed model of the Roberts and
Schaefer Cinder Hoist.
HO Scale
Concrete Coal Dock
Instruction Manual
An experienced modeler should expect to spend about 3 to
4 enjoyable hours for assembly and painting. If you have any
questions please contact us at [email protected]
Figure 1: Assemble the main truss tow-
er of the cinder conveyor.
Insert the floor using tabs to locate it
properly. When assemble the main truss,
make sure the gusset plates face in with
the raised detail facing out.
Gusset Plates
Figure 2: Add the
side shed to the head
house
Bend the walls, floor
and roof on the side
shed. Insert the tabs
into the slots on the
head house of the
main truss cinder con-
veyor.
Figure 3: Add the roof and guide
rails
Bend the roof slightly and add to
the top of the cinder conveyor. In-
sert the guide rails to the inside of
the main truss. The vertical portion
of the guide should be centered on
the side of the truss.
Guide
rails
Center guide rails on these sides
Bend