To install the bail-mount bracket
NotE: You cannot bail mount the GPSMAP 5015/5215 chartplotters. Because of the larger size, you must flush mount the GPSMAP 5015/5215
chartplotter.
1. Using the bail mount as a template, mark the location of the four mounting holes. Be sure to leave at least 5 in. (12.7 cm) of clearance
behind the 4000/5000 series chartplotter for the wiring.
NotE: Mount a GPSMAP 4008/4208/5008/5208 chartplotter 31
(1 m) from a magnetic compass to avoid interference.
2. Using an appropriately sized drill bit, drill the pilot holes for your mounting hardware.
3. Secure the bail mount to the surface with your mounting hardware.
To install the GPSMAP 4000/5000 series chartplotter on the bail-mount bracket
1. Loosely attach the mounting knobs to the GPSMAP 4000/5000 series chartplotter.
2. Slide the chartplotter onto the bail mount, and tighten the mounting knobs.
➊
Flush Mounting the GPSMAP 4000/5000 Series Chartplotter
The flush-mount method you will use with your chartplotter is dependent on the model. Be sure to follow the instructions for your chartplotter
model.
Flush Mounting a GPSMAP 4008/4208/4012/4212 Chartplotter or a GPSMAP 5008/5208/5012/5212
Chartplotter
Hardware (included):
• Flush-mount template
• Rubber gasket
• Four threaded 4 mm mounting studs
• Four 4-mm flat washers
• Four 4-mm lock washers
• Four 4-mm nuts
:
➊
1
/
in. (80 cm), and a GPSMAP 4010/4210/4012/4212/5012/5212 chartplotter 39
2
➋
:
➋
Tools required (not included):
• Jigsaw
• Masking tape
• Scissors
• Drill
• Drill bits—
/
in. (10 mm) and 4 mm
3
8
•
/
in. (2 mm) Allen (Hex) wrench
1
16
• 4 mm socket or wrench
• Center punch and hammer
Mounting knobs ×
Mounting knobs ×
GPSMAP 4000/5000 Series Installation Instructions
3
/
in.
8
ページを印刷する