- ページ 5

船舶用GPSシステム Garmin GPSMAP 8700のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Garmin GPSMAP 8700 27 ページ。
Garmin GPSMAP 8700 にも：取付説明書 (6 ページ), 取付説明書 (8 ページ)

ページを印刷する

Power Considerations

While you can turn the device on and off using the power key, the device will likely not be easily accessible to do

so. You should consider connecting a switch or one of the following to turn the GPSMAP 8700 device on and

off:

• A GRID

™

device

NOTE: A GRID 20 device will not turn the GPSMAP 8700 device on or off. Using the power key on the GRID 20

device will place the GPSMAP 8700 device into sleep mode.

• Another Garmin chartplotter

• A GMM

monitor

™

When power is applied to the GPSMAP 8700 device, the device will turn on. You cannot disable the auto power

on feature.

Garmin Marine Network Considerations

A Garmin Marine Network PoE Isolation Coupler (010-10580-10) must be used when connecting any third-party

device, such as a FLIR

camera, to a Garmin Marine Network. Connecting a Power over Ethernet (PoE) device

directly to a Garmin Marine Network chartplotter damages the Garmin chartplotter and may damage the PoE

device. Connecting any third-party device directly to a Garmin Marine Network chartplotter will cause abnormal

behavior on the Garmin devices, including the devices not properly turning off or the software becoming

inoperable.

This device can connect to additional Garmin Marine Network devices to share data such as radar, sonar, and

detailed mapping. When connecting Garmin Marine Network devices to this device, observe these

considerations.

• All devices connected to the Garmin Marine Network must be connected to the same ground. If multiple

power sources are used for Garmin Marine Network devices, you must tie all ground connections from all

power supplies together using a low resistance connection or tie them to a common ground bus bar, if

available.

• A Garmin Marine Network cable must be used for all Garmin Marine Network connections.

◦ Third-party CAT5 cable and RJ45 connectors must not be used for Garmin Marine Network connections.

◦ Additional Garmin Marine Network cables and connectors are available from your Garmin dealer.

• The NETWORK ports on the device each act as a network switch. Any compatible device can be connected to

any NETWORK port to share data with all devices on the boat connected by a Garmin Marine Network cable.

Station Connection Considerations

This device can be set up in conjunction with other compatible Garmin devices to work together as a station.

When planning stations on your boat, observe these considerations.

• Devices earlier than the GPSMAP 8000 series and GPSMAP 8500 series cannot be used in a station.

• Although it is not necessary, it is recommended that you install all of the devices you plan to use in one

station near each other.

• No special connections are necessary to create a station, as long as all of the devices are connected to the

Garmin Marine Network

• Stations are created and modified using the device software. See the owner's manual provided with the

device for more information.

(Garmin Marine Network Considerations, page

NOTICE

5).