- ページ 4

船舶用GPSシステム Garmin GPSMAP 8700のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Garmin GPSMAP 8700 27 ページ。
Garmin GPSMAP 8700 にも：取付説明書 (6 ページ), 取付説明書 (8 ページ)

Connecting to Power

When connecting the power cable, do not remove the in-line fuse holder. To prevent the possibility of injury or

product damage caused by fire or overheating, the appropriate fuse must be in place as indicated in the product

specifications. In addition, connecting the power cable without the appropriate fuse in place voids the product

warranty.

You should connect the red wire to the power source through the ignition or another manual switch to turn the

device on and off.

1 Route the power cable between the power source and the device.

2 Connect the red power wire to the ignition or another manual switch, and connect the switch to the positive

(+) battery terminal if necessary.

3 Connect the black wire to the negative (-) battery terminal or to ground.

4 Connect the power cable to the device, and turn the locking ring clockwise to tighten it.

Additional Grounding Consideration

This device should not need additional chassis grounding in most installation situations. If you experience

interference, you can use the grounding screw on the housing to connect the device to the water ground of the

boat to help avoid the interference.

Power Cable Extensions

If necessary, the power cable can be extended using the appropriate wire gauge for the length of the extension.

Splice

• Up to 4.6 m (15 ft.): 10 AWG (5.26 mm

• Up to 7 m (23 ft.): 8 AWG (8.36 mm

• Up to 11 m (36 ft.): 6 AWG (13.29 mm

Fuse (10 A, 42 V fast-acting)

20.3 cm (8 in.)

Battery

20.3 cm (8 in.)

11 m (36 ft.) maximum extension

WARNING

) extension wire