Garmin GPSMAP 8700 설치 지침 매뉴얼 - 페이지 4

{카테고리_이름} Garmin GPSMAP 8700에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin GPSMAP 8700 27 페이지.
Garmin GPSMAP 8700에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (6 페이지), 설치 지침 매뉴얼 (8 페이지)

페이지 인쇄

Connecting to Power

When connecting the power cable, do not remove the in-line fuse holder. To prevent the possibility of injury or

product damage caused by fire or overheating, the appropriate fuse must be in place as indicated in the product

specifications. In addition, connecting the power cable without the appropriate fuse in place voids the product

warranty.

You should connect the red wire to the power source through the ignition or another manual switch to turn the

device on and off.

1 Route the power cable between the power source and the device.

2 Connect the red power wire to the ignition or another manual switch, and connect the switch to the positive

(+) battery terminal if necessary.

3 Connect the black wire to the negative (-) battery terminal or to ground.

4 Connect the power cable to the device, and turn the locking ring clockwise to tighten it.

Additional Grounding Consideration

This device should not need additional chassis grounding in most installation situations. If you experience

interference, you can use the grounding screw on the housing to connect the device to the water ground of the

boat to help avoid the interference.

Power Cable Extensions

If necessary, the power cable can be extended using the appropriate wire gauge for the length of the extension.

Splice

• Up to 4.6 m (15 ft.): 10 AWG (5.26 mm

• Up to 7 m (23 ft.): 8 AWG (8.36 mm

• Up to 11 m (36 ft.): 6 AWG (13.29 mm

Fuse (10 A, 42 V fast-acting)

20.3 cm (8 in.)

Battery

20.3 cm (8 in.)

11 m (36 ft.) maximum extension

WARNING

) extension wire