- ページ 19

舶用機器 Garmin Gladiator TR-1のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Garmin Gladiator TR-1 36 ページ。 Garmin tr-1 marine autopilot: user guide
Garmin Gladiator TR-1 にも：インストールとユーザーマニュアル (4 ページ), オーナーズマニュアル (13 ページ)

ページを印刷する

1. Press and hold the [Setup] button on the handheld.

2. Press and light up the [number 9] LED on the handheld.

Release the [Setup] Button.

3. When you are near the waypoint you want to search

from, select "go to" this waypoint on your GPS.

4. With the pilot in heading hold, press and release the [GPS

button] on the handheld, and then press and release one of

the Chevron Buttons. If you pressed the [Right Chevron]

button, the waypoint will remain on your starboard side as

the spiral search unwinds.

o change the setup options for Search Pattern:

You must be in [Auto] or [STBY] mode before selection process can start

1. Press and release the [Setup] Button. The [Setup] LED will illuminate to indicate the system is

ready to take setup commands (button pushes).

2. Select the Setup Code you want to use by pressing and releasing the buttons labeled 2 &5 until the

appropriate LEDs are lit. (See the Code and Setup Choices on the table below)

3. Increase an adjustable parameter one step by each press of the [UP Arrow] button. When the

parameter is adjusted to its maximum value, the [Up Arrow] LED will light. The parameter is

adjusted and is in use by the autopilot immediately.

4. Decrease an adjustable parameter one step by each press of the [Down Arrow] button. When the

parameter is adjusted to its minimum value, the [Down Arrow] LED will light. The parameter is

adjusted and is in use by the autopilot immediately.

5. To save the changes into permanent memory and make the selected function into a

startup default: Press and release the [Setup] button (the [Setup] LED should be lit),

and then press and hold the [Select Load] button. While holding down the [Select Load]

button, press and release the [Deckmount] On/Off button quickly, then release the GPS

[Select Load] button.

Description

Search Spacing

To do an outward spiraling search from a waypoint, setup the special function buttons for sear

patterns. (See page 28 Selecting Special Functions) When you are near the waypoint you wan

to search from, select go to this waypoint on your GPS. With the pilot in heading hold, pres

and release the GPS (Select Load) button and then press and release one of the Bent Arrow

Search Pattern

buttons. If you pressed the Bent Right Arrow button, the waypoint will remain on your

starboard side as the spiral search unwinds. The spacing between the spiral laps is set with set

code 249.

Return to heading hold by pressing one of the straight arrow buttons. An example of the sea

pattern is shown in the figure below.

To do an outward spiraling search from the waypoint, setup the

special nav function

buttons for search

patterns.

Code

Setup Options (Parameters)

50 to 1,000 ft, by 50 ft. increments

Factory Setting