- ページ 23

舶用機器 Garmin Gladiator TR-1のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Garmin Gladiator TR-1 36 ページ。 Garmin tr-1 marine autopilot: user guide
Garmin Gladiator TR-1 にも：インストールとユーザーマニュアル (4 ページ), オーナーズマニュアル (13 ページ)

ページを印刷する

Description

RPM Source Configuration

Code 259:

For single engine installations, set this code to 2 (1 blink) (and hook the blue and black wires up to your

engine tach leads).

Pulses per Revolution

Code 267:

The number of tach pulses per engine revolution is an engine specific parameter. The following settings are

a good starting point, however you need to verify them on operation. V8 engines 4 ppr (3 blinks) Most outboards 6ppr

Show Port RPM

Show Starboard RPM

Transition RPM

Code 348:

Set this code to the RPM's that your boat runs when almost on plane.

Low RPM Limit

Code 357

: If your autopilot runs well at all RPMs but is a little too active at idle, you can increase this low

limit RPM to a setting that is higher than your idle RPM to reduce autopilot rudder activity at idle.

High RPM Limit

Code 359:

If your autopilot runs well at all RPM's but you would like a little stiffer heading hold at the top end,

reducing this setting to an RPM lower than your actual peak RPM will help

Description

Helm Displacement

Pump Displacement

Turns Lock to Lock

Sloppy Linkage Compensation

Code 257:

In case of sloppy and loose steering linkages, increasing this parameter may help to reduce heading

oscillations due to the linkage. Use with caution.

Shadow Drive Desensitize

Code 368:

If the shadow drive is being false tripped, i.e., autopilot is disconnected when the helm is held

still, increasing this parameter may help. False tripping is usually due to leakage of fluid past the helm pump

lock valve. You may need to repair the helm valves if you cannot eliminate false trips.

Shadow Drive Enable

Reversed Hoses

Code 249:

In case of hoses installed backwards, use this code to electronically reverse the steering direction.

Table of Setup Codes

TACHOMETER CODES

Code

259

1, none/ 2, Port/ 3, Starboard/ 4, Both

267

1 to 255 by 1's

Hold Down [Select Load] button: 1000's blink on

Up Arrow 100's blink on Down Arrow

Same As Above

348

100 to 6000 by 100's

357

100 to 6000 by 100's

359

100 to 6000 by 100's

HYDRAULIC CODES

Code

269

.1 to 6 by .1's

169

[Up Arrow] for 4 liter, [Down Arrow] for 2 liter

.1 to 10 by .1's

257

8 settings, 8 for most sloppy

368

1 most sensitive, 40 least sensitive

367

[Up Arrow] for On, [Down Arrow] for Off

249

[Up Arrow] for Reversed, [Down Arrow] for Normal

Values of the Parameters

Factory

Defaults

3000

500

6000

Factory

Defaults

1.7

2 liter

4.5

Norm