- ページ 4

海上ラジオ Garmin GTX 327のPDF パイロット・マニュアルをオンラインで閲覧またはダウンロードできます。Garmin GTX 327 8 ページ。 Mode a/c transponder
Garmin GTX 327 にも：パイロット・マニュアル (8 ページ), パイロット・マニュアル (8 ページ), パイロット・マニュアル (8 ページ), パイロット・マニュアル (4 ページ)

The GTX 327 transponder is powered on by pressing the STBY, ALT or ON keys, or by a remote

avionics master switch (if applicable). After power on a start-up page will be displayed while the

unit performs a self test.

Mode Selection Keys

OFF

STBY

At power on the last active identification code will be

selected. When in standby mode, the transponder will not

reply to any interrogations.

ON Powers on the transponder in Mode A. At power on the last active identifica-

tion code will be selected. In this mode, the transponder replies to interrogations, as

indicated by the Reply Symbol ( ). Replies do not include altitude information.

ALT Powers on the transponder in Mode A and Mode C. At power on the last

active identification code will be selected. In ALT mode, the transponder replies to

identification and altitude interrogations, as indicated by the Reply Symbol ( ).

Replies to altitude interrogations include the standard pressure altitude received

from an external altitude source, which is not adjusted for barometric pressure. The

ALT mode may be used in aircraft not equipped with the optional altitude encoder;

however, the reply signal will not include altitude information.

GTX 327 Configuration Mode

The GTX 327' s configuration, which is normally done at time of installation, influences

many of the unit' s functions described in this manual. If you wish to view or change any of the

GTX 327 configuration parameters, you may access the GTX 327 Configuration Mode. Use

caution when changing configuration. When in doubt, contact your authorized GARMIN

Aviation Service Center. The Configuration Mode should not be used while the aircraft is

airborne.

To use the GTX 327 Configuration Mode:

1. Press and hold the FUNC key while powering on the unit using the STBY, ON, or ALT key

(or using an avionics master switch).

2. Press the FUNC key to sequence through the configuration pages.

3. Use the CRSR key to highlight selectable fields on each page.

4. When a field is highlighted, enter numeric data using the 0 - 9 keys, and select items from

a list using the 8 or 9 keys.

5. Press the CRSR key to confirm list selections.

Powers off the GTX 327.

Powers on the transponder in standby mode.