Garmin GTX 327 파일럿 매뉴얼 - 페이지 4

{카테고리_이름} Garmin GTX 327에 대한 파일럿 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin GTX 327 8 페이지. Mode a/c transponder
Garmin GTX 327에 대해서도 마찬가지입니다: 파일럿 매뉴얼 (8 페이지), 파일럿 매뉴얼 (8 페이지), 파일럿 매뉴얼 (8 페이지), 파일럿 매뉴얼 (4 페이지)

페이지 인쇄
Garmin GTX 327 파일럿 매뉴얼
The GTX 327 transponder is powered on by pressing the STBY, ALT or ON keys, or by a remote
avionics master switch (if applicable). After power on a start-up page will be displayed while the
unit performs a self test.

Mode Selection Keys

OFF
STBY
At power on the last active identification code will be
selected. When in standby mode, the transponder will not
reply to any interrogations.
ON Powers on the transponder in Mode A. At power on the last active identifica-
tion code will be selected. In this mode, the transponder replies to interrogations, as
indicated by the Reply Symbol ( ). Replies do not include altitude information.
ALT Powers on the transponder in Mode A and Mode C. At power on the last
active identification code will be selected. In ALT mode, the transponder replies to
identification and altitude interrogations, as indicated by the Reply Symbol ( ).
Replies to altitude interrogations include the standard pressure altitude received
from an external altitude source, which is not adjusted for barometric pressure. The
ALT mode may be used in aircraft not equipped with the optional altitude encoder;
however, the reply signal will not include altitude information.
GTX 327 Configuration Mode
The GTX 327' s configuration, which is normally done at time of installation, influences
many of the unit' s functions described in this manual. If you wish to view or change any of the
GTX 327 configuration parameters, you may access the GTX 327 Configuration Mode. Use
caution when changing configuration. When in doubt, contact your authorized GARMIN
Aviation Service Center. The Configuration Mode should not be used while the aircraft is
airborne.
To use the GTX 327 Configuration Mode:
1. Press and hold the FUNC key while powering on the unit using the STBY, ON, or ALT key
(or using an avionics master switch).
2. Press the FUNC key to sequence through the configuration pages.
3. Use the CRSR key to highlight selectable fields on each page.
4. When a field is highlighted, enter numeric data using the 0 - 9 keys, and select items from
a list using the 8 or 9 keys.
5. Press the CRSR key to confirm list selections.
Powers off the GTX 327.
Powers on the transponder in standby mode.