- ページ 6

ホブ AEG 20604 GのPDF 操作およびインストール手順をオンラインで閲覧またはダウンロードできます。AEG 20604 G 27 ページ。 Gas hob
AEG 20604 G にも：操作および設置マニュアル (26 ページ)

WHEN THE HOB IS FIRST INSTALLED

Once the hob has been installed, it is important to remove any protective materials,

which were put on in the factory.

Operation

HOB BURNERS

To light a burner, turn the relevant control knob anticlockwise to the maximum position. At

the same time push the electric ignition button which is marked with a little spark. Then

adjust the flame as required.

If the burner does not ignite, turn the control knob to zero, and try again.

When switching on the mains, after installation or a power cut, it is quite normal for the

spark generator to be activated automatically.

To ensure maximum burner efficiency, you should only use pots and pans with a flat

bottom fitting the size of the burner used (see table).

Burner

Large (rapid)

Medium (semi-rapid)

Small (Auxiliary)

As soon as a liquid starts boiling, turn down the flame so that it will barely keep the liquid

simmering.

If you use a saucepan which is smaller than the recommended size, the flame will

spread beyond the bottom of the vessel, causing the handle to overheat.

Take care when frying food in hot oil or fat, as the overheated splashes could easily

ignite

If the control knobs become difficult to turn, please contact your local AEG Service

Force Centre.

minimum

maximum

diameter

160 mm.

240 mm.

120 mm.

220 mm.

80 mm.

160 mm.