ページを印刷する
44
www.aeg.com
Problem
The washing results
are not satisfactory.
Too much foam in the
drum during the wash-
ing cycle.
After the washing cy-
cle, there are some de-
tergent residues in the
dispenser drawer.
After the check, activate the appliance. The programme continues from the point of
interruption.
If the problem occurs again, contact the Authorised Service Centre.
The necessary data for the service centre are on the rating plate.
14.2 Emergency door opening
In case of power failure or functioning
failure the appliance door remains
locked. The washing programme
continues when the power is restored. If
the door remains locked in case of
failure, it is possible to open it using the
emergency unlock function.
Before opening the door:
CAUTION!
Risk of burns! Make sure
that the water
temperature is not too
high and the laundry is not
hot. If necessary, wait until
they cool down.
CAUTION!
Risk of injury! Make sure
that the drum is not
rotating. If necessary, wait
until the drum stops
rotating.
Possible solution
• Increase the detergent quantity or use a different detergent.
• Use special products to remove the stubborn stains before
you wash the laundry.
• Make sure that you set the correct temperature.
• Decrease the laundry load.
• Reduce the quantity of detergent.
• Make sure that the flap is in the correct position (UP for pow-
der detergent - DOWN for liquid detergent).
• Make sure you have used the detergent dispenser according
the indications given in this user manual.
Make sure that the water
level inside the drum is not
too high. If necessary,
proceed with an
emergency drain (refer to
«Emergency drain» in
«Care and cleaning»
chapter).
To open the door, proceed as follows:
1. Press the On/Off button to switch the
appliance off.
2. Disconnect the mains plug from the
mains socket.
3. Pull the emergency unlock trigger
downward once. Pull it once again,
keep it tensed and, in the meanwhile,
open the appliance door. The
emergency unlock trigger is located
where indicated by the following
picture.