- ページ 3

洗濯機 AEG Automatic washing machinesのPDF 設置・接続方法をオンラインで閲覧またはダウンロードできます。AEG Automatic washing machines 14 ページ。 Aeg automatic washing machines

Important Safety Information

The safety of AEG appliances is in accordance with recognised techno-

logical standards and appliance safety legislation. We nevertheless feel

that it is important to acquaint you with the following safety guide-

lines.

• This appliance is heavy, care should be taken when moving it.

• When moving, do not tip the washing machine onto it's front or left

hand side (viewed from the front). This is to prevent the possibility of

electrical components becoming wet.

• Before installation inspect the machine for transport damage. Do not

connect the appliance if it is damaged – contact your retailer.

• Ensure all packaging and transit bolts/bar have been removed, see

„Removing of Transit Packaging". Failure to remove packaging and

transit bolt/bar may cause serious damage to the product or property.

• Any plumbing work required to install this appliance should be

carried out by a qualified plumber or competent person.

• Any electrical work required to install this appliance should be carried

out by a qualified electrician or competent person.

• Check the electricity supply is the same as that indicated on the

rating plate of the appliance.

• Should the appliance mains cable need to be adapted for any reason

this should only be carried out by a qualified/competent person.

• In the case of a permanent connection it is necessary that you install

a double pole switch between the appliance and the electricity supply

(mains), with a minimum gap of 3 mm between the switch contacts

and of a type suitable for the required load in compliance with the

electrical regulations.

• The switch must not break the yellow and green earth cable at any

point.

• Care must be taken to ensure that the appliance does not stand on

the electrical supply cable.

• The installation should comply with local water authority and

building regulations requirements.

• Appliances designed for cold water connection must not be

connected to hot water.