AEG Automatic washing machines Kurulum ve Bağlantı Talimatları - Sayfa 3

Yıkayıcı AEG Automatic washing machines için çevrimiçi göz atın veya pdf Kurulum ve Bağlantı Talimatları indirin. AEG Automatic washing machines 14 sayfaları. Aeg automatic washing machines

Sayfayı Yazdır

Important Safety Information

The safety of AEG appliances is in accordance with recognised techno-

logical standards and appliance safety legislation. We nevertheless feel

that it is important to acquaint you with the following safety guide-

lines.

• This appliance is heavy, care should be taken when moving it.

• When moving, do not tip the washing machine onto it's front or left

hand side (viewed from the front). This is to prevent the possibility of

electrical components becoming wet.

• Before installation inspect the machine for transport damage. Do not

connect the appliance if it is damaged – contact your retailer.

• Ensure all packaging and transit bolts/bar have been removed, see

„Removing of Transit Packaging". Failure to remove packaging and

transit bolt/bar may cause serious damage to the product or property.

• Any plumbing work required to install this appliance should be

carried out by a qualified plumber or competent person.

• Any electrical work required to install this appliance should be carried

out by a qualified electrician or competent person.

• Check the electricity supply is the same as that indicated on the

rating plate of the appliance.

• Should the appliance mains cable need to be adapted for any reason

this should only be carried out by a qualified/competent person.

• In the case of a permanent connection it is necessary that you install

a double pole switch between the appliance and the electricity supply

(mains), with a minimum gap of 3 mm between the switch contacts

and of a type suitable for the required load in compliance with the

electrical regulations.

• The switch must not break the yellow and green earth cable at any

point.

• Care must be taken to ensure that the appliance does not stand on

the electrical supply cable.

• The installation should comply with local water authority and

building regulations requirements.

• Appliances designed for cold water connection must not be

connected to hot water.