- ページ 3
ラベルメーカー Brother PT-2040SCのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Brother PT-2040SC 17 ページ。
ページを印刷する
1
GETTING STARTED
Installing Power Supply
Battery Compartment
Cover
When using AC Adapter
(AD-24ESA-01/
AD-24ESAW-01):
1. Insert the Power
Adapter cord into the AC
Adapter Jack on the side
of the machine.
2. Insert the Power
Adapter into a standard
AC electrical outlet.
When using batteries:
1. Make sure the power is
off.
2. With the LCD facing
down, remove the Battery
Compartment Cover by
pressing the grooved tab
and pushing in the
direction of the arrow, as
illustrated.
3. This label maker
requires six (6) AA
alkaline batteries, not
included.
Make sure that the
positive (+) and negative
(-) ends of the batteries
match the marks inside
the battery compartment.
Note:
Always replace all six
batteries at the same time
using brand new ones.
4. Attach the Battery
Compartment Cover by
inserting the three hooks
at the bottom into the
slots on the machine, then
press down firmly until it
clicks into place.
When running a memory
backup, we recommend
using both the Power
Adapter AND batteries, in
the event that one or the
other power method fails.
Installing a Tape Cassette
Tape
Exit Slot
Release
Lever
1. Open the Cassette
Cover by lifting both sides
at the same time.
2. Insert the Tape Cassette
following the drawing
marked inside the case.
Gently press the Tape
Cassette into the label
maker until it clicks into
place.
• Use only tape widths of
0.13" (3.5 mm), 0.23"
(6 mm), 0.35" (9 mm),
0.47" (12 mm) or 0.70"
(18 mm).
• If your TZe tape is
packaged with protective
plastic, be sure to remove
the plastic before inserting
the Tape Cassette.
• Use Brother TZe tapes
with this machine.
3. Close the Cassette
Cover and gently press
until it clicks into place.