- ページ 5
ラベルメーカー Brother QL-1110NWBのPDF クイック・セットアップ・マニュアルをオンラインで閲覧またはダウンロードできます。Brother QL-1110NWB 9 ページ。
Brother QL-1110NWB にも： クイック・セットアップ・マニュアル (9 ページ), マニュアル (2 ページ)
ページを印刷する
6. LED Indicators
The indicators light and flash to indicate the printer status.
Status LED
Not lit
Steady green light
Flashing green light
Steady orange light
Flashing orange light
Steady red light
Flashing red light
* "Rapidly" means at 0.3 second intervals.
NOTE
See the Troubleshooting section in this guide for tips on how to fix errors.
Wi-Fi LED
Wi-Fi LED
Not lit
Steady green light
Flashing green light
Bluetooth LED
Bluetooth
Not lit
Steady blue light
Flashing blue light
Condition
Power Off
The printer is in one of the following modes:
• Idle mode
• Initialising mode
• Feeding mode
• Printing mode
• Cutting mode
• Mass storage mode
• WPS setting mode
The printer is doing one of the following:
• Receiving data
• Cancelling the print job
One of the following is occurring:
• The DK Roll Compartment Cover is open. Close the DK Roll Compartment Cover correctly.
• Reset mode is on.
• The Cutter (
) Button was pressed while resetting.
For more information on resetting the printer, see the User's Guide.
• System Off mode
If the orange light flashes at 0.5 second intervals:
• Continuously: The printer is in cooling mode.
• Three times: The printer is being discovered by another device.
Boot mode
Contact Brother customer service.
If the red light flashes at one second intervals, one of the following errors has occurred:
• Roll end error
• No media error
• Wrong media error
• Feed error
• Cover open error
• Transferred data error
• Memory full error
• Access Point connection error
If the red light flashes at a rate of one second off, rapidly* on, rapidly off, rapidly on, then one of
the following errors has occurred:
• Cutter error
• Mass storage error
• USB host power supply excessive voltage error
• USB host unsupported device connection error
If the red light flashes at a rate of one second off, rapidly* on, rapidly off, rapidly on, rapidly off,
rapidly on, then the USB host hub connection error has occurred.
To identify the cause of the error, press a button other than the Power (
pattern will change, indicating the cause of the error. Contact Brother customer service.
Condition
Wi-Fi Off
Wi-Fi is On and connected.
If the green light is on for 1 second, off for 2 seconds, Wi-Fi is On, but not connected.
Condition
Bluetooth Off
Bluetooth is On.
If the blue light flashes at 0.5 second intervals: Pairing
If the blue light flashes at 1 second intervals: automatically-reconnecting
) button. The flash