- ページ 29

サーバー Fujitsu PRIMERGY Econel 200 S2のPDF サービス補足マニュアルをオンラインで閲覧またはダウンロードできます。Fujitsu PRIMERGY Econel 200 S2 39 ページ。

Replacement routines

4.6

Replacing the intrusion switch

Part number: A3C40082393

The intrusion switch monitors the removing of the side cover of the housing.

Ê Remove the side cover as described in section "Preparation" on page 17.

Ê Remove the processor fan 2 as described in section "Removing the

processor fan 2" on page 17.

Figure 13: Removing the intrusion switch

Ê Press sideward on the hooks of the intrusion switch holder and pull down the

holder.

Ê Disconnect the cable from the system board (connector Intrusion, see

system board foil D2530).

Ê Release the cable from the cable clamps, pull it through the recesses of the

chassis.

Ê Connect the cable to the system board (connector Intrusion, see system

board foil D2530).

Ê Route the new cable as the old one.

Econel 200 S2

Replacing the intrusion switch

Service Supplement