Fujitsu PRIMERGY Econel 200 S2 Manual do suplemento de serviço - Página 29
Procurar online ou descarregar pdf Manual do suplemento de serviço para Servidor Fujitsu PRIMERGY Econel 200 S2. Fujitsu PRIMERGY Econel 200 S2 39 páginas.
Imprimir página
Replacement routines
4.6
Replacing the intrusion switch
Part number: A3C40082393
The intrusion switch monitors the removing of the side cover of the housing.
Ê Remove the side cover as described in section "Preparation" on page 17.
Ê Remove the processor fan 2 as described in section "Removing the
processor fan 2" on page 17.
Figure 13: Removing the intrusion switch
Ê Press sideward on the hooks of the intrusion switch holder and pull down the
holder.
Ê Disconnect the cable from the system board (connector Intrusion, see
system board foil D2530).
Ê Release the cable from the cable clamps, pull it through the recesses of the
chassis.
Ê Connect the cable to the system board (connector Intrusion, see system
board foil D2530).
Ê Route the new cable as the old one.
Econel 200 S2
Replacing the intrusion switch
Service Supplement
29