- ページ 18

サーバー Fujitsu Primergy RX100 S3のPDF サービス補足マニュアルをオンラインで閲覧またはダウンロードできます。Fujitsu Primergy RX100 S3 45 ページ。
Fujitsu Primergy RX100 S3 にも：スタートマニュアル (9 ページ)

Replacing the LED board

4.2

Replacing the LED board

The PRIMERGY RX100 S3 server's chassis ID is stored on both the LED board

and the system board. If in the event of failure, the LED board or the system

board which has to be replaced must have the chassis ID rewritten.

Beside the CPU temperature sensor and housing temperature sensor provided

on the system board, an ambient temperature sensor is also included on the

LED board. In case of a defective ambient temperature sensor, please replace

the LED board.

Ê Open the server as described in the section "Preparation" on page 17.

Figure 2: Removing the LED board

Ê Remove the two screws (see arrows).

Ê Unplug the cable.

Ê Pull the LED board in the direction of the housing rear side (approx. 1 centi-

meter).

Ê Take the LED board out of the housing.

Ê Push the new LED board into the front panel. Make sure that the buttons and

LEDs fit in the right positions.

Service Supplement

Replacement routines

RX100 S3