- ページ 25
スキャナー Fujitsu fi-4220C2のPDF はじめにをオンラインで閲覧またはダウンロードできます。Fujitsu fi-4220C2 30 ページ。 Flatbed scanner
Fujitsu fi-4220C2 にも： インストール手順マニュアル (7 ページ), インストール手順マニュアル (9 ページ), パンフレット＆スペック (2 ページ), インストール手順 (3 ページ), 洗浄方法 (2 ページ)
ページを印刷する
Symptom
Paper frequently multi
feeds
Paper does not feed
(pick error occurs fre-
quently, or document
stops midway).
Are the scanned images
elongated?
Is there a shadow on the
leading edge of the
scanned image?
Check this item
Have the document requirements
of the fi-4220C2 Operator's
Guide's "Document Quality" and
the "Multi feed Detection Condi-
tions" of chapter 6 been satisfied?
Are the documents placed properly
in the ADF paper chute?
Is the stack of document thicker
than 5 mm?
Is the Pad ASSY dirty?
Is the Pad ASSY worn out?
Have the document requirements
of the fi-4220C2 Operator's
Guide's "Document Quality" and
the "Multi feed Detection Condi-
tions" of chapter 6 been satisfied?
Is the Pick roller dirty?
Is the Pick roller worn out?
Is there any dirt or dust in the docu-
ment feed path?
Are the Feed rollers dirty?
Have you adjusted the scan scale?
Are the Feed rollers dirty?
Adjust the offset.
fi-4220C2 Image Scanner Getting Started
Remedy
Use document conditions that meet the
"Document Quality" and the "Multi feed
Detection Conditions" in chapter 6 of the fi-
4220C2 Operator's Guide.
Fan the documents before scanning. Cor-
rectly align the document stack and load
them on the ADF paper chute. Refer to "2.1
Installing the Scanner" on page 3 for
details.
Reduce the number of sheets of the stack
to a thickness of 5 mm or less.
Clean the Pad ASSY. Refer to Operator's
Guide in "3.3. Cleaning the ADF".
Replace the Pad ASSY. Refer to Opera-
tor's Guide in "4.2. Replacing the Pad
ASSY".
Use document conditions that meet the
"Document Quality" and the "Multi feed
Detection Conditions" in the chapter 6 of
the fi-4220C2 Operator's Guide.
Clean the Pick roller. Refer to Operator's
Guide in "3.3. Cleaning the ADF".
Change the Pick roller. Refer to Operator's
Guide in "4.3. Replacing the Pick Roller".
Remove any dirt or dust from the docu-
ment feed path.
Clean the Feed rollers. Refer to Operator's
Guide in "3.3. Cleaning the ADF".
For Windows 98, Windows Me, Windows
2000, WindowsXP, select "Scanners and
Cameras" in the control panel, then click
the [Device Set] tab to adjust scale.
For Windows 95, Windows NT 4.0, right
click the Scanner Control Center in the task
tray, select [Options] and adjust the scan
scale.
Clean the Feed rollers. Refer to Operator's
Guide in "3.3. Cleaning the ADF".
For Windows 98, Windows Me, Windows
2000, WindowsXP, adjust the [Sub-scan
Setting] on [Scanners and Cameras] in the
control panel.
For Windows 95, Windows NT 4.0, right
click the Scanner Control Center, select
[Options]-[Sub-scan Setting] and adjust the
offset.
AP-2