Fujitsu fi-4220C2 Memulai - Halaman 25

Jelajahi secara online atau unduh pdf Memulai untuk Pemindai Fujitsu fi-4220C2. Fujitsu fi-4220C2 30 halaman. Flatbed scanner
Juga untuk Fujitsu fi-4220C2: Manual Prosedur Instalasi (7 halaman), Manual Prosedur Instalasi (9 halaman), Brosur & Spesifikasi (2 halaman), Prosedur Instalasi (3 halaman), Petunjuk Pembersihan (2 halaman)

Halaman Cetak

Symptom

Paper frequently multi

feeds

Paper does not feed

(pick error occurs fre-

quently, or document

stops midway).

Are the scanned images

elongated?

Is there a shadow on the

leading edge of the

scanned image?

Check this item

Have the document requirements

of the fi-4220C2 Operator's

Guide's "Document Quality" and

the "Multi feed Detection Condi-

tions" of chapter 6 been satisfied?

Are the documents placed properly

in the ADF paper chute?

Is the stack of document thicker

than 5 mm?

Is the Pad ASSY dirty?

Is the Pad ASSY worn out?

Have the document requirements

of the fi-4220C2 Operator's

Guide's "Document Quality" and

the "Multi feed Detection Condi-

tions" of chapter 6 been satisfied?

Is the Pick roller dirty?

Is the Pick roller worn out?

Is there any dirt or dust in the docu-

ment feed path?

Are the Feed rollers dirty?

Have you adjusted the scan scale?

Are the Feed rollers dirty?

Adjust the offset.

fi-4220C2 Image Scanner Getting Started

Remedy

Use document conditions that meet the

"Document Quality" and the "Multi feed

Detection Conditions" in chapter 6 of the fi-

4220C2 Operator's Guide.

Fan the documents before scanning. Cor-

rectly align the document stack and load

them on the ADF paper chute. Refer to "2.1

Installing the Scanner" on page 3 for

details.

Reduce the number of sheets of the stack

to a thickness of 5 mm or less.

Clean the Pad ASSY. Refer to Operator's

Guide in "3.3. Cleaning the ADF".

Replace the Pad ASSY. Refer to Opera-

tor's Guide in "4.2. Replacing the Pad

ASSY".

Use document conditions that meet the

"Document Quality" and the "Multi feed

Detection Conditions" in the chapter 6 of

the fi-4220C2 Operator's Guide.

Clean the Pick roller. Refer to Operator's

Guide in "3.3. Cleaning the ADF".

Change the Pick roller. Refer to Operator's

Guide in "4.3. Replacing the Pick Roller".

Remove any dirt or dust from the docu-

ment feed path.

Clean the Feed rollers. Refer to Operator's

Guide in "3.3. Cleaning the ADF".

For Windows 98, Windows Me, Windows

2000, WindowsXP, select "Scanners and

Cameras" in the control panel, then click

the [Device Set] tab to adjust scale.

For Windows 95, Windows NT 4.0, right

click the Scanner Control Center in the task

tray, select [Options] and adjust the scan

scale.

Clean the Feed rollers. Refer to Operator's

Guide in "3.3. Cleaning the ADF".

For Windows 98, Windows Me, Windows

2000, WindowsXP, adjust the [Sub-scan

Setting] on [Scanners and Cameras] in the

control panel.

For Windows 95, Windows NT 4.0, right

click the Scanner Control Center, select

[Options]-[Sub-scan Setting] and adjust the

offset.

AP-2