- ページ 16
ソフトウェア Brother Quattro 6000DのPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。Brother Quattro 6000D 29 ページ。 Kit de actualización iii
Brother Quattro 6000D にも： マニュアル (42 ページ), 操作マニュアル (50 ページ), 操作マニュアル (6 ページ), ユーザーマニュアル (48 ページ), 操作マニュアル (21 ページ), (取扱説明書 (49 ページ), (取扱説明書 (21 ページ), (取扱説明書 (48 ページ)
ページを印刷する
d
Press
.
→ The screen changes, and all keys and operation
buttons are locked.
e
Using the presser foot lever, raise the presser
foot.
f
To bring the bobbin thread above the fabric,
rotate the handwheel counterclockwise while
holding the upper thread.
g
As shown below, pull the upper thread to pull
the bobbin thread up through the fabric.
a
Upper thread
b
Bobbin thread
Memo
• If the bobbin thread cannot be pulled up, use an awl
to create small hole to help pull bobbin thread to
surface.
h
Press
to unlock all keys and buttons.
i
Lower the presser foot.
j
While holding both the upper thread and the
bobbin thread, sew a section of the pattern.
k
Stop the machine, and then tie the upper
thread and the bobbin thread together to
secure the threads.
l
Start sewing again to finish the pattern.
m
Raise the needle and presser foot, remove the
embroidery frame, and then cut the upper
thread and the bobbin thread.
When cutting the threads, be sure to leave an
adequate length of thread so they can be
properly secured.
n
Using a hand sewing needle such as a ribbon
embroidering needle, pull the bobbin thread
to the top (wrong side) of the fabric, and then
tie the upper thread and the bobbin thread
together.
Memo
• If there is a gap between the start point and end
point of the pattern, cut the threads, remove the
fabric from the machine, and then use a ribbon
embroidering needle to hand sew stitches to
connect the starting and ending points.
15