- ページ 19

ソフトウェア Brother Quattro 6000DのPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。Brother Quattro 6000D 29 ページ。 Kit de actualización iii
Brother Quattro 6000D にも：マニュアル (42 ページ), 操作マニュアル (50 ページ), 操作マニュアル (6 ページ), ユーザーマニュアル (48 ページ), 操作マニュアル (21 ページ), (取扱説明書 (49 ページ), (取扱説明書 (21 ページ), (取扱説明書 (48 ページ)

TROUBLESHOOTING

Several solutions for minor problems are described below. If the problem persists, contact your nearest authorized

dealer.

■ The thread was accidentally cut

automatically and the bobbin thread is

caught inside the machine

Cut the thread near the fabric above the

needle plate, and then remove the fabric.

Thread

Note

• If an embroidery pattern was sewn, remove the

embroidery frame.

Remove the bobbin, and then hold it out

toward the left side of the machine.

Lower the presser foot.

Press the "Thread Cutter" button again, and

then pull the thread out to the left while the

thread cutter is operating.

CAUTION

• Do not pull on the thread with excessive force,

otherwise the machine may be damaged.

■ The pattern is misaligned

Refer to "ADJUSTING THE THREAD TENSION" and

increase the upper thread tension. If the pattern is still

misaligned, reduce the tension of the bobbin thread.

Example: Decorative Stitch

Correct tension

The upper thread tension is too loose, or the bobbin

thread tension is too tight.

■ The bobbin thread catches on the tension

spring of the bobbin case

Sew with no tension applied to the bobbin thread.

(Refer to "When tension is not applied to the bobbin

thread" on page 8.)